Models > RT18HDXPQ01

RT18HDXPQ01 Roper Refrigerator - Overview

Get Parts and Repair Help for RT18HDXPQ01

If you know the refrigerator repair part you need, you can browse the list of all parts on the RT18HDXPQ01, or you can search by name or part description. You can also find your part by where it is located on the RT18HDXPQ01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for RT18HDXPQ01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$76.26

Condenser Fan Motor Kit

This kit includes the motor, fan blade, wire harness and screws. ***NOTE: The manufacturer has changed the product to appear different than the original, but will still function...

$25.79

Bimetal Defrost Thermostat

This clip-on thermostat will sense the temperature increase in the evaporator during the defrost cycle and will cycle the defrost heater off after the ice or frost is melted.

$53.82

Crisper Pan

$45.28

Evaporator Fan Motor - 60Hz 120V

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated. NOTE: This motor uses 2 brackets which are sold separately.

$90.45

Add-On Icemaker Kit

This kit includes ice bucket and water valve and fits Whirlpool models manufactured from 1993 to present.

$3.96

End Cap Trim Piece

$3.76

Door Shelf Retainer Bar End Cap

$7.87

Light Rocker Switch

$13.17

Crisper Drawer Rail

$2.70

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

My refrigerator stopped cooling and the freezer section stopped freezing

  • Customer: garth from forest lake MN
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 103 of 112 people found this instruction helpful
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck let's give her a shot ... read more

Seven year old condenser fan was making noise when it was running.

  • Customer: Josue from Jacksonville NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 95 of 100 people found this instruction helpful
The process to repair was very simple, I removed the back of the refrigerator to expose the motor area. I then removed three screws that held the condenser motor in place. once it was loose I detactched the electrical harness and removed the old motor. I then placed the new motor in place and secured it with the screws and reattached the new electrical harne... read more

Fridge was warm. No air circulating at all. Food was spoiling Fridge was just over 1 year old

  • Customer: Brian from Smock PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 50 of 57 people found this instruction helpful
First I removed the two screws that secure the guard in bottom back of the freezer and removed it . Next I removed the two screws that secure the guard on the back wall of the freezer and removed it. There are three wires connected to the motor, I unplugged those and removed the two screws that secure the motor and removed it. I swapped the grommets, blade a... read more