Quick Question!

Have you ever purchased from PartSelect.com before?

Models > RT18HDXFN01

RT18HDXFN01 Roper Refrigerator - Overview

Get Parts and Repair Help for RT18HDXFN01

If you know the refrigerator repair part you need, you can browse the list of all parts on the RT18HDXFN01, or you can search by name or part description. You can also find your part by where it is located on the RT18HDXFN01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for RT18HDXFN01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$36.07

Handle End Cap Kit

This kit includes both upper and lower door handle end caps for both freezer and fresh food door handles. This is only available in chrome. All other colors are discontinued. Handle is NOT included. Handles must be ordered separately.

$35.17

Light Socket Kit

The bulb is sold separately.

$7.22

Touch-Up Paint - White

18ml

$99.84

Fresh Food Door Gasket

This white door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

$11.07

Spray Paint - 12 oz. - White

$44.80

Compressor Relay and Overload

May differ in appearance, but functions same as original. The overload protects a motor from overheating and the relay boosts the compressor.

$74.75

Door Handle Kit of 2 - Black

Almond and white handle no longer available. NOTE: As per the manufacture the handle may have to be cut to fit.

$6.80

Touch-up Paint - Black

16ml

$88.58

Freezer Door Gasket

This door gasket is used to seal the freezer door when closed.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The frost free feature of the freezer was freezing over with ice and cooling coils were being insulated with thickening frost which caused the cooling air to rise in temperature from -5 degrees to 20 degrees.

  • Customer: Lawrence from Grahamsville, NY
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver
  • 321 of 377 people found this instruction helpful
I troubleshot the problem by reading the electrical schematic and concluding the heating elements (defrost cables) were either defective or the bi-metal temp sensor was open. When closed the temp sensor completes the circuit for the current to flow through the heaters to defrost the cooling coils every 8 hours and then when the bimetal opens at 55 degrees t... read more

My refrigerator stopped cooling and the freezer section stopped freezing

  • Customer: garth from forest lake, MN
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 172 of 190 people found this instruction helpful
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck let's give her a shot ... read more

Temperature unstable

  • Customer: Duane from Albany, OR
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 65 of 83 people found this instruction helpful
Open the door. Removed two screws holding the cover of the thermostat. There is a clip which holds the thermostat in place. Remove the clip. Take out the thermostat. Remove the thermocouple (the long grey metal with the coil at the end) which is also held in place by a clip. Replace with the new thermostat and thermocouple and clip into place. Replace t... read more