Quick Question!

Have you ever purchased from PartSelect.com before?

Models > RT14DKYKQ01

RT14DKYKQ01 Roper Refrigerator - Overview

Get Parts and Repair Help for RT14DKYKQ01

If you know the refrigerator repair part you need, you can browse the list of all parts on the RT14DKYKQ01, or you can search by name or part description. You can also find your part by where it is located on the RT14DKYKQ01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for RT14DKYKQ01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the RT14DKYKQ01

[Viewing 5 of 5]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$28.79

Defrost Timer

This eight-hour defrost timer will replace most other defrost timers. This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater. The best way to make sure you get the correct timer for your refrigerator is to conduct a search for your model number.

$47.35

Capacitor

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$48.32

Evaporator Fan Motor - 60Hz 120V

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated. NOTE: This motor uses 2 brackets which are sold separately.

$84.92

Icemaker

This kit includes everything needed to install the new icemaker. Note: This part has been updated by the manufacturer, it may differ in appearance but will still function the sam...

$7.60

Icemaker Water Fill Tube Kit

This kit comes with a fill tube and a compression nut.

$12.56

Light Rocker Switch

This light switch is triggered by the door opening and closing.

$4.76

End Cap Trim Piece

Sold individually.

$2.80

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$2.80

Screw

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

My refrigerator stopped cooling and the freezer section stopped freezing

  • Customer: garth from forest lake, MN
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 189 of 211 people found this instruction helpful
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck let's give her a shot ... read more

Broken elbow on icemaker water fill tube.

  • Customer: Charles from Orland Hills, IL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 105 of 115 people found this instruction helpful
Removed 2 screws holding water fill tube to rear of refrigerator and pulled out, matched old part with new to make sure of proper match. Guide new fill tube thru hole, making sure it is aligned with slot in ice cube tray on inside of freezer. Install new plastic line from water pump outlet to water fill tube, check for leaks, job done. read more

Fridge was warm. No air circulating at all. Food was spoiling Fridge was just over 1 year old

  • Customer: Brian from Smock, PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 88 of 100 people found this instruction helpful
First I removed the two screws that secure the guard in bottom back of the freezer and removed it . Next I removed the two screws that secure the guard on the back wall of the freezer and removed it. There are three wires connected to the motor, I unplugged those and removed the two screws that secure the motor and removed it. I swapped the grommets, blade a... read more