Models > RST380 Maytag

RST380 Caloric Range - Overview

Get Parts and Repair Help for RST380

If you know the range repair part you need, you can browse the list of all parts on the RST380, or you can search by name or part description. You can also find your part by where it is located on the RST380 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for RST380 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.53

Light Bulb - 40W

Sold individually.

$45.54

Flat Style Oven Igniter

You must reuse the original bracket. Be very careful to not touch the black element part of this igniter as it is very fragile.

$6.09

Set Button Knob

This set button knob is sold individually. It is all black in color and is made entirely of plastic.

$2.71

SCREW

Sold individually.

$38.39

Oven Light

This oven light assembly is a little over four inches long. It is a six hundred an sixty watt light bulb.

$32.13

Hinge Kit - Right Side

This hinge is located on the right side of the door.

$31.88

Hinge Kit - Left Side

$33.42

Gas Burner Cap with Spark Electrode

This stainless steel surface burner cap assembly comes with a spark ignition electrode .

$30.76

Gas Spark Ignition Switch

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.

$143.58

Electronic Relay Board

This board sends information (such as temperature of oven, bake, broil) to the main control board during specific functions.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven wouldn't heat. Glow ignitor was weak and wouldn't ignite flame.

  • Customer: John from Niles, MI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 56 of 60 people found this instruction helpful
After shutting off the gas and removing the oven door, which simply slid off of the hinges, I removed the oven plate. The ignitor was attached to the manifold. I removed that and noted the wires were attached back behind a hole in the back of the oven. I thought I would have to access them from the back but when I pulled on them I was able to reach them ... read more

pre- igniter went bad. No spark

  • Customer: Edward from Schaghticoke, NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 15 of 21 people found this instruction helpful
The trick with any appliance is to remove all the extras,before you get to the problem.Considering that it has electricity, the first step was to turn it off.
After that it was a matter of removing the top burners,range knobs and locate the panel screws that secure it to the stove.Locate the part,remember the colors of where the wires go,remove,replace ... read more

hard to get old one out

  • Customer: robert from chatham, VA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 27 of 60 people found this instruction helpful
easy to put in read more