Models > RS267LBSH/XAA

RS267LBSH/XAA Samsung Refrigerator - Overview

Get Parts and Repair Help for RS267LBSH/XAA

If you know the refrigerator repair part you need, you can browse the list of all parts on the RS267LBSH/XAA, or you can search by name or part description. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$7.80

Defrost Temperature Sensor

This part is used to sense the temperature in the cabinet.

$4.21

LEVER DISPENSER-ICE;AD,A

$58.02

AQUA-PURE PLUS FILTER

$1.98

COVER-SENSOR;AD,PP,T1.0,

$10.21

SWITCH DOOR-R;-,SLIDING,

$1.98

CAM-HINGE RISER LOW;USP0

$23.04

ASSY GUARD REF-LOW;A-TOP

$10.02

SUPPORT-ICE MAKER;DISP,U

$9.68

RELAY PROTECTOR O/L;4TM4

$9.50

RELAY PTC;J531Q32E4R7M18

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Refrigerator Temperature Blinking

  • Customer: Christopher from Queen Creek AZ
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
I removed all of the internal shelves from the refrigerator side. I then removed the cooling panels from the bottom area. this exposed the fan assembly and cooler. I found ice all over the unit. I had to unplug the refrigerator and used a hair dryer to melt the ice away. I then found the sensor and replace it. After putting the refrigerator back together, I ... read more

Lever dispenser-ice was broken.

  • Customer: RUSSELL from LAS VEGAS NV
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Using the putty knife, pry off the faceplate for the ice/water dispenser. disconnect the wire harness. Using Philips head screwdriver, remove the dispenser assembly. Remove the old dispenser and replace. Reverse for reassembly. Note * I should have bought the water dispenser lever and replaced it as well since I had the assembly out. Secondary note * be mind... read more

Refrigerator side wasn't cooling properly. Was staying at 55 degrees.

  • Customer: Robert from Simi Valley CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
Took off the plastic panel in the interior. As usual, the evaporator was completely iced up. Took most of the time to de-ice it with a heat gun. Tested the components and the temperature sensor was bad which is on the top end of the evaporator fins. The ohms test wasn't any different whether hot or cold. I keep a spare sensor on hand because this is the thir... read more