Models > RS267LBBP/XAA

RS267LBBP/XAA Samsung Refrigerator - Overview

Get Parts and Repair Help for RS267LBBP/XAA

If you know the refrigerator repair part you need, you can browse the list of all parts on the RS267LBBP/XAA, or you can search by name or part description. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.


Defrost Temperature Sensor

This part is used to sense the temperature in the cabinet.


TRAY ICE;AD,PP,-,-,-,-,N




Evaporator Fan Motor

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.













Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Refrigerator section stopped cooling evaporator was iced up

  • Customer: Nikhil from Mountainside NJ
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
1:Removed heating element and sensors from new evaporator assembly supplied by partSelect. 2: removed the evap covers, and defrosted the evaporator in place used a hair dryer to speed things up. 3: Pried open the old evap heater from the evaporator assembly while still in place. replaced the new heating element and sensors 4: closed up the covers and powered... read more

Refrigerator Temperature Blinking

  • Customer: Christopher from Queen Creek AZ
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
I removed all of the internal shelves from the refrigerator side. I then removed the cooling panels from the bottom area. this exposed the fan assembly and cooler. I found ice all over the unit. I had to unplug the refrigerator and used a hair dryer to melt the ice away. I then found the sensor and replace it. After putting the refrigerator back together, I ... read more

Lever dispenser-ice was broken.

  • Customer: RUSSELL from LAS VEGAS NV
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Using the putty knife, pry off the faceplate for the ice/water dispenser. disconnect the wire harness. Using Philips head screwdriver, remove the dispenser assembly. Remove the old dispenser and replace. Reverse for reassembly. Note * I should have bought the water dispenser lever and replaced it as well since I had the assembly out. Secondary note * be mind... read more