The ice maker cube tray holds the water that comes from the ice maker during the process of it becoming ice. This part is white in color and made of plastic. All you will need for this repair is a fla...
This sensor cover, also known as the ice maker thermostat cover, is a genuine OEM replacement part for Samsung refrigerators. It is made of durable white plastic and has measurements of approximately ...
This genuine OEM water filter is made for your side-by-side or French door refrigerator, working to reduce impurities like iron, chlorine, and rust for better-tasting water. With a capacity of 300 gal...
This fan motor is compatible with most frost-free Samsung refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, cooling the ...
This is a refrigerator ice dispenser lever. It is clear and made entirely out of plastic. The function of the ice dispenser lever is to dispense ice when the lever is pushed. If the lever is cracked o...
No Longer Available
Questions And Answers for RS2521SW
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Unplugged Unit Removed back cover removed fan assembly removed fan balde opened motor case replaced motor sealed the motor case fastened to fan shroud re installed fan blade re attacehd to frig- Carefull of the coolant lines Plugged in motor assembly Replaced back cover Re Plugge
... Read mored in Frig to AC outlet.
unplugged first, then Pulled out frig and took out fan motor. plugged in to be sure it worked. waited few minutes and it started running. then placed everything back where it belonged. Talked to appliance store and told me what the problem was but it would take longer for them to get then for me to order on line. Best way to get it do
... Read morene... No directions on box...
Using the putty knife, pry off the faceplate for the ice/water dispenser. Disconnect the wire harness. Using philips head screwdriver, remove the dispenser assembly. Remove the old dispenser and replace. Reverse for reassembly. Note * I should have bought the water dispenser lever and replaced it as well since I had the assembly out.
... Read more Secondary note * be mindful during reassembly to not put pressure on the water dispenser or have a glass handy. :)
