RS22AQXFW01 Roper Refrigerator - Instructions

I watched the parts select YouTube video. The repair was a piece of cake. We now have ice again. The part was correct and arrived in just 48 hours. Perfect in every way.

First I used some glue to stop the crack from spreading, and that worked for a while, but then I deceided to get a new replacement part. What I got was better than the original one as it had a white protective piece over the end of the drawer and I believe that will give more protection to the drawer. My kids did not always close the drawer all the ways and that is how the crack started. So now the refrigerator looks like new again.

Watch the video was very helpful. I'm just a women and I did it all by myself. Thanks for the help of the video.

I followed the instructions that came with the part. Less than five minutes it was good as new.

I watched the video on you tube and followed his instructions. It was very easy, it took about 20 minutes from start to finish.

Unplug refrigerator and turn water supple off. Remove three mounting mounting screws and unplug the old ice maker.(there is a latch on the plug to release it) Remove shutoff arm from old unit or if ordered seperatly with the ice maker, install shutoff arm on the new unit. Plug the new unit in (latch will snap into place when plug is properly seated.) Install the bottom screw (leave screws loose until all are started in the orginal holes). Tighten screws and you are done. Turn the water on and plug refrigerator in. After about an hour or two the ice maker will be cold enough to start making ice. In about five hours or so you will see the first ice cubes!!!!

I got the new part and unplugged the refrigerator. I removed the wire auto shut-off. I removed the old motor assy. I checked to see if the motor quit running at the same locations as the new one before removing the entire ice maker. Lucky it did, so I installed the new motor assy without having to remove the ice maker. It took 10 minutes at the most.

part better than original just unscrewed and removed original. new one fit just right.

Verified that the sensors were working. After removing the Ice maker assembly from the sliding track, I found that the indexed drive wheel on the motor had broken off from the shaft mounting. I ordered the Icemaker control and motor assembly from Partselect and swapped out the bad part. It only has three screws to remove and replace so it's fast and easy to fix.

I watched the video and made sure my replacement ice maker matched the original. On my particular icemaker/refigerator combination, the electrical connection was slightly different than what was shown in the video, but the process for removal and replacement was very similar. I believe if more videos were available that were of the quality of the one on this website, there would be more people attempting to replace parts. I believe I saved over $200 by doing it myself. Kudos to the website and video people.

The repair was simple. Unplug the refrigerator, unplug the power connector from the fan and remove 3 screws. I removed the fan blade clip with the pliers and cleaned it off. Reversed the process, cleaned all the dust out with my shop vac and all works perfectly now. It took longer to pull the fridge out of it's normal position than to perform the repair. Every day it continues to work is one more day I don't spend $2000 or more on a replacement.

We were afraid of breaking the new part.But after watching the repair video about how much pressure to apply the part snapped right in. Thamk you for the video it helped alot.found the part quick and easy and it was shipped fast to us problem solved.

just removed tho old one and inserted the new one job complete.

Push it in to place very easy.

Pull the ice maker out using a nutdriver Pull the use a srew driver to remove the srews did the same to replace it put it back in had ice in 20 min