Models > RMS363U (P1142710N L)

RMS363U (P1142710N L) Caloric Range - Overview

Get Parts and Repair Help for RMS363U

If you know the range repair part you need, you can browse the list of all parts on the RMS363U, or you can search by name or part description. You can also find your part by where it is located on the RMS363U by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for RMS363U parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$18.07

2 Piece Broiler Pan

$16.02

Top Burner Spark Ignition Electrode with Retaining Clip

$2.70

Screw

This screw is sold individually.

$51.27

Gas Burner Grate

Sold individually.

$27.46

Suface Burner Ignition Switch

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.

$3.82

Frame Screw

Sold Individually.

$39.95

Surface Burners Spark Module Kit

$31.16

IGNITER-SP

$19.23

Top Burner Knob

Sold Individually. This knob accepts a D-shaped shaft.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

There was a crack in the porcelain not letting it spark

  • Customer: Billy from Martinsville IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 16 of 21 people found this instruction helpful
I used a screwdriver to pry the electrode assy. out of the burner. then disconnected the wire.
Then just connected the new electrode and place the assy, in the burner. read more

Ignitor did not spark when turning the know

  • Customer: Richard from Lansing MI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 9 people found this instruction helpful
Had to remove the 4 range knobs, and the oven knob and then the facie. Two screws under the end caps and two on each side from the back on each end. Design defect: one of these screws which attaches through the frame to the facie also attaches the support which holds up the range top. Take that one off last. Remove the two wires that attach to the oven light... read more

gas burners and gas oven would not light

  • Customer: nicholas from livermore CA
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 7 of 8 people found this instruction helpful
unplug the oven and pull it away from the wall. looking at the oven from the back, the spark module is at the bottom on the lower left. there is a two piece sheetmetal cover over the area of the spark module. use a phillips head screwdriver to remove five screws and the covers come off. the spark module is the blue cube with four push on wire connectors.... read more