Models > RMS361-OF

RMS361-OF (RMS3610OF) Caloric Range - Overview

Get Parts and Repair Help for RMS361-OF

If you know the range repair part you need, you can browse the list of all parts on the RMS361-OF, or you can search by name or part description. You can also find your part by where it is located on the RMS361-OF by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$6.46

Burner Bowl

This pan is dishwasher safe and comes one to a package.

$51.27

Gas Burner Grate

Sold individually.

$29.40

Suface Burner Ignition Switch

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.

$19.23

Top Burner Knob

Sold Individually. This knob accepts a D-shaped shaft.

$53.46

Front Burner

SCREW

REGULATOR-

ASSY,THERMOSTAT KIT

DISCONTINUED

CLOCK

Common Symptoms of the RMS361-OF [Viewing 1 of 23]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ignitor did not spark when turning the know

  • Customer: Richard from Lansing MI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 9 people found this instruction helpful
Had to remove the 4 range knobs, and the oven knob and then the facie. Two screws under the end caps and two on each side from the back on each end. Design defect: one of these screws which attaches through the frame to the facie also attaches the support which holds up the range top. Take that one off last. Remove the two wires that attach to the oven light... read more

Left rear burner would not ignite

  • Customer: John from Perth Amboy NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 5 of 6 people found this instruction helpful
Removed the burner plates. Lifted up the range top. Removed the knobs. Unbolted the 2 rounded nuts at top of face plate. Removed the 4 screws that hold the face plate in place from behind. Un plugged the old switch and plugged in the new one and bam! The burner worked. Thanks, Super fast shipping! The part was here in less than 36 hours. John, N.J. read more

Right front gas burner ignitor wouldn't spark

  • Customer: Joseph from Lake George CO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 5 of 7 people found this instruction helpful
I used the experience of another user posted on your web site. I removed all the gas control knobs and then I followed his instructions about removing the four phillps head screws that held the front plate in place. Once I had it loose and flipped the plate out, it was simple to disconnect the old ignitor switch and install the new one. Simply reversing t... read more