Quick Question!

Have you ever purchased from PartSelect.com before?

Models > RME32302

RME32302 Roper Range - Overview

Get Parts and Repair Help for RME32302

If you know the range repair part you need, you can browse the list of all parts on the RME32302, or you can search by name or part description. You can also find your part by where it is located on the RME32302 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for RME32302 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

Order within the next 12 hrs and your part ships today!
$44.49

Bake Element

This bake element has push-on terminals and is found on the bottom of the oven.

Order within the next 12 hrs and your part ships today!
$18.87

Receptacle Kit

This surface burner receptacle assembly comes with the receptacle, two wires, two wire nuts, and two pieces of heat-shrink tubing.

Order within the next 12 hrs and your part ships today!
$5.15

Screw

This screw is sold individually.

Order within the next 12 hrs and your part ships today!
$5.15

Screw

This screw is sold individually.

Order within the next 12 hrs and your part ships today!
$5.15

Screw

Sold individually. Lock washers are used with screws when vibration from an appliance may cause the screw to loosen. Lock washers are also used in the electrical components of an appliance to ensure an electrical connection is not lost.

Order within the next 12 hrs and your part ships today!
$7.60

Rear Drawer Glide

Order within the next 12 hrs and your part ships today!
$9.63

8" Drip Bowl - Black

This black porcelain drip bowl with a hole in the bottom is intended for use with some electric ranges and cooktops.

Order within the next 12 hrs and your part ships today!
$41.46

Oven Rack

Sold individually.

Order within the next 12 hrs and your part ships today!
$7.60

Front Drawer Glide

Sold individually.

Order within the next 12 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

heating element burnt up

  • Customer: Esther from San Antonio, TX
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 70 of 75 people found this instruction helpful
first I pulled the stove from the wall. Then unplugged the stove from the wall (electric stove) for safety. then I removed the middle back panel screws(2) and then the panel. I then pulled the wires off the heating element that was bad. I took the screws (2) off the heating element inside the oven. I had to use WD-40 to loosen the screws because with th... read more

Stove would not heat up

  • Customer: Tim from Pittsford, NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 68 of 81 people found this instruction helpful
Cut old wires to receptacle, striped the wires, wire nutted to new receptacle, screwed new receptacle into stove and installed heating element.

Piece of cake, but then again my degree is in electrical engineering so I should be able to handle a couple of wire nuts. read more

The burner would keep heating after turning off the switch

  • Customer: RON from KAUFMAN, TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 51 of 56 people found this instruction helpful
Start by turning off the power to the range.
It was fairly easy to take the "Control Deck" off the top of the range by removing about 8 screws. I leaned the deck forward without removing any wires except a green ground that was held on by one of the screws.
There are two small screws under the switch knob holding the Infinite Switch to the panel. ... read more