Models > RLS313 Maytag

RLS313 Caloric Range - Overview

Get Parts and Repair Help for RLS313

If you know the range repair part you need, you can browse the list of all parts on the RLS313, or you can search by name or part description. You can also find your part by where it is located on the RLS313 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for RLS313 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$18.07

2 Piece Broiler Pan

$6.46

Burner Bowl

This pan is dishwasher safe and comes one to a package.

$51.27

Gas Burner Grate

Sold individually.

$27.46

Suface Burner Ignition Switch

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.

$18.62

Oven Sides Seal

It is made of black rubber and has a metal hook in each end.

$31.16

IGNITER-SP

$49.95

Front Burner

$31.23

PILOT-OVEN

$2.70

Frame Screw

Sold Individually.

Common Symptoms of the RLS313 [Viewing 1 of 23]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ignitor did not spark when turning the know

  • Customer: Richard from Lansing MI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 9 people found this instruction helpful
Had to remove the 4 range knobs, and the oven knob and then the facie. Two screws under the end caps and two on each side from the back on each end. Design defect: one of these screws which attaches through the frame to the facie also attaches the support which holds up the range top. Take that one off last. Remove the two wires that attach to the oven light... read more

Left rear burner would not ignite

  • Customer: John from Perth Amboy NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 5 of 6 people found this instruction helpful
Removed the burner plates. Lifted up the range top. Removed the knobs. Unbolted the 2 rounded nuts at top of face plate. Removed the 4 screws that hold the face plate in place from behind. Un plugged the old switch and plugged in the new one and bam! The burner worked. Thanks, Super fast shipping! The part was here in less than 36 hours. John, N.J. read more

electric ignite gas stove kept clicking the ignitor unless unplugged from electrical outlet

  • Customer: Diana from Jacksonville FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 5 of 6 people found this instruction helpful
I removed the 2 screws that held the housing on at the back of the stove. Then I removed the 2 screws that held the module to the back of the stove. Since I am not an experienced electrical person (I am a female nurse in the operating room), I unplugged 1 wire at a time from the old module and plugged it into the new module. I repeated this step with each wi... read more