Models > RJ734GP2BG

RJ734GP2BG Hotpoint Oven - Overview

Get Parts and Repair Help for RJ734GP2BG

If you know the oven repair part you need, you can browse the list of all parts on the RJ734GP2BG, or you can search by name or part description. You can also find your part by where it is located on the RJ734GP2BG by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for RJ734GP2BG parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the RJ734GP2BG [Viewing 3 of 3]

$36.10

Bake Element

This bake element is found on the bottom of the oven.

$4.27

Single Heating Element Support Clip

This metallic clip is used to help support the broil element. Sold individually.

$39.45

Broil Element - 240V

This oven broil element has push-on terminals.

$89.55

Oven Sensor

This sensor detects the temperature within the oven cavity.

$1.70

Screw

This screw is sold individually.

$2.36

Single Screw Only

Sold Individually.

$4.41

Light Cover

$16.87

Broiler Pan - Large

Includes the pan and grate.

$15.59

RACK OVEN

$2.36

SCREW

Sold Individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven tempature was approximately 150 degrees to low

  • Customer: James from Austin TX
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 137 of 160 people found this instruction helpful
This repair is EASY if you know how to use an ohm meter. If not, seek help for this step.

SYMPTOM:
The oven (JKP27WOP3WG or JKP27WP3WG and many ovens like it ) was not getting hot enough. Verifying the cooking temperature with an typical oven thermometer, I was able to determine that the oven was cooking temperature was about 150 degrees t... read more

bake element shorted out, sparking like a sparkler

  • Customer: Carl from Wynnewood PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 40 of 43 people found this instruction helpful
first, made sure circuit breaker was off
second, used nut driver to remove 2 screws on old element, pulled it from the back of the oven
third, removed 2 wires from old element (spade connectors)
fourth, connected new element and pushed back into oven.
fifth, reinstalled 2 screws securing new element

this was all done by my 15 y... read more

The broiler element caught fire and burned out while I was broiling a steak.

  • Customer: Dianne from Rockville MD
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 30 of 36 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches, but I had not turned off the power.
So, I shorted out one of the wires. Then I turned off the power but was afraid to go any farther.
An appliance repairman was at my house that day fixing my dryer seal. He was able to pull the wires through... read more