Models > RGJ515GEL3

RGJ515GEL3 Hotpoint Oven - Overview

Get Parts and Repair Help for RGJ515GEL3

If you know the oven repair part you need, you can browse the list of all parts on the RGJ515GEL3, or you can search by name or part description. You can also find your part by where it is located on the RGJ515GEL3 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for RGJ515GEL3 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the RGJ515GEL3 [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$89.55

Oven Sensor

This sensor detects the temperature within the oven cavity.

Order within the next 5 hrs and your part ships today!
$2.79

SCREW

Sold Individually.

Order within the next 5 hrs and your part ships today!
$2.79

Single Screw Only

Sold Individually.

Order within the next 5 hrs and your part ships today!
$3.00

Screw

Sold Individually.

Order within the next 5 hrs and your part ships today!
$4.48

SCREW

Order within the next 5 hrs and your part ships today!
$3.00

SCREW-10AB

Order within the next 5 hrs and your part ships today!
$3.21

WASHER

Order within the next 5 hrs and your part ships today!
$21.79

SWITCH-LITE

Order within the next 5 hrs and your part ships today!
$16.23

SCREW

Oven Door Seal

This oven door seal can be used for the top or the bottom.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven tempature was approximately 150 degrees to low

  • Customer: James from Austin TX
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 160 of 185 people found this instruction helpful
This repair is EASY if you know how to use an ohm meter. If not, seek help for this step.

SYMPTOM:
The oven (JKP27WOP3WG or JKP27WP3WG and many ovens like it ) was not getting hot enough. Verifying the cooking temperature with an typical oven thermometer, I was able to determine that the oven was cooking temperature was about 150 degrees t... read more

Oven would not heat to the correct temperature

  • Customer: Michael from Lawrenceville GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 33 of 52 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires read more

F2 error message on my GE oven indicated need for new heat sensor

  • Customer: Joseph from Brick NJ
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers
  • 11 of 12 people found this instruction helpful
After unscrewing the old heat sensor from inside the oven, I pulled the range away from the wall, got behind it and removed the small panel over the heat sensor. Naturally, the plastic clips connecting the heat sensor to the range wiring wouldn't come apart, so I eventually had to simply pry them apart with two pliers. Then, naturally, the new plastic connec... read more