Models > RGJ515GEL1

RGJ515GEL1 Hotpoint Oven - Overview

Get Parts and Repair Help for RGJ515GEL1

If you know the oven repair part you need, you can browse the list of all parts on the RGJ515GEL1, or you can search by name or part description. You can also find your part by where it is located on the RGJ515GEL1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for RGJ515GEL1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the RGJ515GEL1 [Viewing 4 of 4]

$89.55

Oven Sensor

This sensor detects the temperature within the oven cavity.

$2.36

SCREW

Sold Individually.

$2.36

Single Screw Only

Sold Individually.

$2.79

Screw

Sold Individually.

$4.30

SCREW

$2.79

SCREW-10AB

$3.00

WASHER

$21.24

SWITCH-LITE

$15.37

SCREW

$13.46

OV LAMP HLDR

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven tempature was approximately 150 degrees to low

  • Customer: James from Austin TX
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 152 of 176 people found this instruction helpful
This repair is EASY if you know how to use an ohm meter. If not, seek help for this step.

SYMPTOM:
The oven (JKP27WOP3WG or JKP27WP3WG and many ovens like it ) was not getting hot enough. Verifying the cooking temperature with an typical oven thermometer, I was able to determine that the oven was cooking temperature was about 150 degrees t... read more

Oven would not heat to the correct temperature

  • Customer: Michael from Lawrenceville GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 32 of 51 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires read more

oven shut down code F3

  • Customer: Richard from Jupiter FL
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 13 of 17 people found this instruction helpful
As has been said shut down unit,Breaker fuse.If you do not have install info.Get a copy on line. If you have another set of hands it would not hurt.! this has been stated before. Remove door, Remove 4 screws , to slide unit out,I used a saw horse with some cribing secured to the horse to get height, Pull the oven out so that the two front supports are on th... read more