Models > RGJ515GEH1

RGJ515GEH1 Hotpoint Oven - Overview

Get Parts and Repair Help for RGJ515GEH1

If you know the oven repair part you need, you can browse the list of all parts on the RGJ515GEH1, or you can search by name or part description. You can also find your part by where it is located on the RGJ515GEH1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the RGJ515GEH1 [Viewing 1 of 1]

$16.87

Broiler Pan - Large

Includes the pan and grate.

$30.43

Oven Igniter

Be very careful to not touch the black element part of this igniter as it is very fragile.

OV LT SOCKET

$94.61

Burner Igniter

Usually used for Broil.

$95.46

HINGE ASM RH

$101.64

HINGE ASM LH

DISCONTINUED

BRKT

$19.21

DISCONTINUED

$9.20

CLIP-THERMO BULB

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven wouldn't light, burners worked fine (gas oven).

  • Customer: Martin from Newport Beach CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 18 of 24 people found this instruction helpful
Unplugged the power cord from the oven. Unfortunately I couldn't figure out how to remove the broiler drawer so I didn't have a lot of room to work. Basically I had to unscrew one Phillips screw to remove the metal housing that shields the wiring and connectors from direct flame of the oven. Once I removed the housing it was a matter of removing 2 wire caps... read more

Worn out oven igniter

  • Customer: Phil from Lancaster PA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 9 of 12 people found this instruction helpful
Disconnect the power cord.
Lift the Oven door UP to remove it from the Hinges. Then unscrew the Nut/screw and remove the floor of the oven. Remove the broiler drawer. Remove the screws from the cover plate along the back wall of the oven where the wires go. Observe where the old wires go/went.
Cut the wire from the old igniter 3 : from the igni... read more

Oven won't Light

  • Customer: Charlotte from Tulsa OK
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 3 of 4 people found this instruction helpful
Replaced igniter in oven, Removed 2 screws in oven floor and removed floor panel. Removed 3 screws to remove the whole flame pipe assy. Disconnected 2 connectors on the ignition assy. Replaced ignition assy. with the cheapest ignition assy. spliced the 2 wires with the connectors of the old assy. using the supplied ceramic wire nuts and re assembled. Part f... read more