Models > RGB746HED3WH

RGB746HED3WH Hotpoint Range - Overview

Get Parts and Repair Help for RGB746HED3WH

If you know the range repair part you need, you can browse the list of all parts on the RGB746HED3WH, or you can search by name or part description. You can also find your part by where it is located on the RGB746HED3WH by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for RGB746HED3WH parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$35.87

Flat Style Oven Igniter Kit

The flat style gas oven igniter included in this kit has a body length of 3-3/4". This kit comes with a mounting bracket and a wire connector with a plug. *Please note: the connector plug might need to be removed and spliced to range wiring using porcelain wire nuts. This part is used to heat your oven.

$41.27

Oven Rack

Sold individually.

$12.37

Double Burner Pan - Right Side

$12.82

Double Burner Pan - Left Side

$17.95

Burner Head - Medium - 9500

$89.55

Oven Sensor

This sensor detects the temperature within the oven cavity.

$2.23

Drawer Support

$1.34

Lens

$17.52

Grate

Sold individually. Must order quantity needed.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The igniter glowed, but never got hot enough to ignite the propane, so I did smell propane.

  • Customer: Sidney from Marysville CA
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 478 of 479 people found this instruction helpful
First, I removed the two screws that held the heat shield in place. Second, I removed the one screw that held a small wire covering. That covering kept the wires inside the back wall of the range. Third, I removed the two screws that held the Igniter Kit, and unplugged it from the back of the range. I then carefully put the new igniter in, and reassemble... read more

oven would not light or keep temp.

  • Customer: zack from corning CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench set
  • 398 of 399 people found this instruction helpful
first I thought it was a faulty gas valve, so I pulled it out, started researching for a replacement part, found your site and started research. I discovered thhat the igniter was the culprit, that info. saved me about a week of time and a 100 bucks, so I installed the gas safety valve back in the oven, patience is the word for the day, you cross thread thi... read more

Oven wouldn't heat. This degraded over several weeks.

  • Customer: Durwood from Suffield CT
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 249 of 320 people found this instruction helpful
1. Pulled the 110V power plug. It was not necessary to turn off the gas; just be careful not to stretch or pinch the flexhose behind the stove.
2. Removed the oven door by opening a couple of inches then lifting upward.
3. Removed the warming drawer by pulling out to the stop, then pushing the small levers on the side of the track to release.
read more