Models > RFS12MPSA

RFS12MPSA (P1330206M) Amana Microwave - Overview

Get Parts and Repair Help for RFS12MPSA

If you know the microwave repair part you need, you can browse the list of all parts on the RFS12MPSA, or you can search by name or part description. You can also find your part by where it is located on the RFS12MPSA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

SCREW

$11.80

Black Sleeve Diode

$221.07

Magnetron

This part is used to generate microwave energy/heat.

$3.71

FUSE- 10 A

$49.30

Interlock Micro Switch Kit

Used with commercial microwaves. This part is used to stop the flow of electrical current when the door is opened to prevent any microwave energy escaping.

$169.19

Magnetron

This part is used to generate microwave energy/heat.

$52.71

THERMAL CUT-OUT

$6.97

SCREW

FUSE- 12 A

$26.21

Filter, Choke

Common Symptoms of the RFS12MPSA [Viewing 1 of 1]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

loud buzzing noise

  • Customer: Sandra from coto de caza CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 30 of 54 people found this instruction helpful
The repair went well...I am so glad that I read this info before buying a new microwave....it saved me lots of money. I did have a repair man come and look at it and he told me to buy a new one but it cost alot of money when it wasn't necessary. I did the repair and I was very proud of myself.
Three men watched a woman fix this and it was no problem...... read more

part completely desintegrated .it was easy to spot

  • Customer: nelson from gardena CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 3 of 3 people found this instruction helpful
removed cover first ,then I disconnected the leads and removed the holding screws that held it in place. Then I installed the new part by reversing the prosedure. read more

microwave would not heat.

  • Customer: outstanding from Galena MD
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
hardest part was taking the microwave down off of the wall to gain access to the diode. Thought if was the transformer but ended up being just a blown diode. remove and replace and bench test. that part took 15 minutes . moral of the story don't boil water under the side of the microwave that holds the electric components. read more