Models > RF364PXMW

RF364PXMW Whirlpool Range - Overview

Get Parts and Repair Help for RF364PXMW

If you know the range repair part you need, you can browse the list of all parts on the RF364PXMW, or you can search by name or part description. You can also find your part by where it is located on the RF364PXMW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for RF364PXMW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Models starting with RF364PXMW

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$37.54

Bake Element

This bake element has push-on terminals and is found on the bottom of the oven.

$2.70

Screw

This screw is sold individually.

$3.96

Rear Drawer Glide

$2.70

Screw

$43.62

Oven Rack

Sold individually.

$66.29

Sensor

This temperature sensor detects the temperature within the oven cavity.

$3.96

Front Drawer Glide

Sold individually.

$4.11

SCREW

$17.77

Terminal Block

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

heating element burnt up

  • Customer: Esther from San Antonio TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 25 of 27 people found this instruction helpful
first I pulled the stove from the wall. Then unplugged the stove from the wall (electric stove) for safety. then I removed the middle back panel screws(2) and then the panel. I then pulled the wires off the heating element that was bad. I took the screws (2) off the heating element inside the oven. I had to use WD-40 to loosen the screws because with th... read more

The burner would keep heating after turning off the switch

  • Customer: RON from KAUFMAN TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 22 of 24 people found this instruction helpful
Start by turning off the power to the range.
It was fairly easy to take the "Control Deck" off the top of the range by removing about 8 screws. I leaned the deck forward without removing any wires except a green ground that was held on by one of the screws.
There are two small screws under the switch knob holding the Infinite Switch to the panel. ... read more

Socket Light had a bad thread

  • Customer: Edmund from Emporium PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 21 people found this instruction helpful
Socket Lite come with clips attached to the outside
of the housing. After you unhook the 3 lead wires
that are attached to the unit. All you have to do is push in on the clips and release the unit. Then you
snap in the new unit. Attach the 3 wire leads, put a
oven bulb in the socket end, and the install the light cover read more