Models > RE253G1

RE253G1 Whirlpool Air Conditioner - Overview

Get Parts and Repair Help for RE253G1

If you know the air conditioner repair part you need, you can browse the list of all parts on the RE253G1, or you can search by name or part description. You can also find your part by where it is located on the RE253G1 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$4.70

Washer

This part is located on the drum roller support shaft.

Order within the next 5 hrs and your part ships today!
$19.02

Control Knob

Sold individually. This light gray knob accepts a D-shaped shaft.

Order within the next 5 hrs and your part ships today!
$3.36

Hex Nut

Part may differ in appearance, but functions same as original.

Order within the next 5 hrs and your part ships today!
$2.70

Single Hex Head Screw

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Order within the next 5 hrs and your part ships today!
$22.20

ADHESIVE

This is a high temperature adhesive.

Order within the next 5 hrs and your part ships today!
$50.25

Air Filter

Sold individually.

Order within the next 5 hrs and your part ships today!
$35.89

Winter Air Conditioner Cover

Order within the next 5 hrs and your part ships today!
$34.96

VALVE

Order within the next 5 hrs and your part ships today!
$27.94

Putty

Permagum sealer for refrigerant line insulation.

Order within the next 5 hrs and your part ships today!
$166.30

Fan Motor - 60Hz

Order within the next 5 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The cooling selector switch stopped working

  • Customer: Vince from Redding CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 11 of 19 people found this instruction helpful
First removed the power and front panel. Then in order to get to the damaged cooling selector switch, I needed to first drill out three riviets holding the small front pannel that the switch and thermostat selector switches are mounted on.

Then it was a simple matter to unscrew two small screws holding the broken cooling selector switch in place.... read more

Thermostat was shorting out

  • Customer: Tina from Decherd TN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 3 of 4 people found this instruction helpful
First remove two screw pulledout 3 inches diconneccected 3 wire and put back. read more

Filter was filthy, no telling how long it had been since changed

  • Customer: SHIRLEY G. from Mabank TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 4 of 8 people found this instruction helpful
Took out old filter and replaced it with the new filter read more