RC30DE60PB0 Uni Cooktop - Instructions

no problem slightly different shape than original but labels for wires matched up mounting screws aligned perfectly works great

Don't be put off when you first get the new switch. It's not an exact duplicate to the one your replacing. You will notice that the new switch has 5 electrical connectors and you'll see 6 wires on the old one. start by removing the L1 wire(s) off the old switch, you will see that it actually has 2 wires connected to the same connector. Now connect to the L1 position on the new switch. Continuie with taking one wire at a time off the old switch and connect to the corresponding connector on the new switch (all the connectors are coded the same, ex. L1, P, etc....) Once complete the switch and burner worked perfectly

repair it

Followed the procedure used in replacing the previous switches. The part came without a bushing needed to adjust the height of the knob sticking above the surface of controls. Fortunately, I could use the bushing from the previous part. I suggest a bushing should be included with this part.

1. I cut off the circuit breaker for the stovetop and removed items on the shelf directly under the cooktop
2. I looked under the cooktop and unscrewed the two screws holding the panel under the switch controls and removed the panel.
3. I pulled the knob up off of the bad cooktop control switch.
4 I unscrewed the two screws holding the bad cooktop switch control.
5. I looked under the cooktop and pulled the bad cooktop control switch down so I could remove the wires connected to it.
6. I got the new switch control and put the wires from the old control onto the new control, one-at-a-time, to the same labelled connection on the new control, which was a somewhat different arrangement.
7. I worked the new control up through the wires and put the knob shaft up through the hole in the cooktop.
8. Back on top, I installed the two screws I had removed from the old switch control to hold the new control to the stovetop.
9. I reinstalled the control knob onto the control.
10. I turned back on the circuit breaker for the stovetop and checked out the operation of the new switch control. It worked fine.
11. I turned the circuit breaker back off and reinstalled the panel cover under the switch controls, with the two screws I had removed earlier.
12. I turned back on the circuit breaker for the stovetop.
13 I put the items back onto the shelf directly under the stovetop.
14. Job done!

Take picture of current connection diagram.

Remove the 3 screw on the bottom cover, and 2 screw holding the switch and then switch your wires out.

Turn off braker,lift cooktop from counter and remove acces panel unscrew switch from cooktop and replace one wirer at the time than resrew everything together.

Shut power off to appliance. Replaced burner switch. Removed three screws in access panel to get to switch. Removed two screws that held switch in place. Removed wires from old switch and attached to new switch. Replaced switch screws and then replaced access panel screws. Easy fix. Saved an $85.00 service call fee.

hinged burner up to the rear. removed hex nut to unmount old switch. 5 wires pushed onto new switch same orientation.mounted switch with 2 very short screws no problem very easy. turned breakers on checked operation a- ok.