Models > RBD245PRS02

RBD245PRS02 Whirlpool Oven - Overview

Get Parts and Repair Help for RBD245PRS02

If you know the oven repair part you need, you can browse the list of all parts on the RBD245PRS02, or you can search by name or part description. You can also find your part by where it is located on the RBD245PRS02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$42.96

Bake Element

$2.70

Screw

This screw is sold individually.

$5.54

Touch-Up Paint - White

$37.04

Thermal Overload Safety Thermostat

This part establishes and maintains the internal temperature of the oven cavity.

$24.55

Light Bulb - 120-130V - 15W

Sold individually.

$63.84

Temperature Sensor

This temperature sensor detects the temperature within the oven cavity.

$49.85

Broil Element

This broil element is found on the roof of the oven.

$2.70

Screw

This screw is sold individually.

$2.70

SCREW

$44.65

Inner Oven Door Glass

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

No heat after cleaning oven

  • Customer: Frederick from St. Louis MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 40 of 46 people found this instruction helpful
This built-in oven was slid out of it's space and set on a box. I removed the back cover with nut driver and located the safety overload device. removed nuts and used pliers to remove wires and replace them. The power must be off to do this repair.Replaced the cover and slid back into place. This could be a lot more difficult if your power cord or gas line ... read more

I broke the Bake Element while cleaning the oven.

  • Customer: Daniel from Cheraw SC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 20 of 22 people found this instruction helpful
I removed the two screws that held the bake element in place. Next I removed the Bake Element. I had to unscrew the oven to go behind it because when one piece off of the element broke, it slide back behind the oven. I pushed the wire back thru the piece holes, connected the Element, and pushed the element with the wires back through the holes. I rescrewed t... read more

Scratches in Surface

  • Customer: Michelle from Richardson TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 10 of 12 people found this instruction helpful
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great. read more