Models > RBD245PDT15

RBD245PDT15 Whirlpool Oven - Overview

Get Parts and Repair Help for RBD245PDT15

If you know the oven repair part you need, you can browse the list of all parts on the RBD245PDT15, or you can search by name or part description. You can also find your part by where it is located on the RBD245PDT15 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$42.96

Bake Element

$2.70

Screw

This screw is sold individually.

$5.54

Touch-Up Paint - White

$37.04

Thermal Overload Safety Thermostat

This part establishes and maintains the internal temperature of the oven cavity.

$24.55

Light Bulb - 120-130V - 15W

Sold individually.

$63.84

Temperature Sensor

This temperature sensor detects the temperature within the oven cavity.

$49.85

Broil Element

This broil element is found on the roof of the oven.

$2.70

Screw

This screw is sold individually.

$2.70

SCREW

$44.65

Inner Oven Door Glass

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

No heat after cleaning oven

  • Customer: Frederick from St. Louis MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 40 of 46 people found this instruction helpful
This built-in oven was slid out of it's space and set on a box. I removed the back cover with nut driver and located the safety overload device. removed nuts and used pliers to remove wires and replace them. The power must be off to do this repair.Replaced the cover and slid back into place. This could be a lot more difficult if your power cord or gas line ... read more

I broke the Bake Element while cleaning the oven.

  • Customer: Daniel from Cheraw SC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 20 of 22 people found this instruction helpful
I removed the two screws that held the bake element in place. Next I removed the Bake Element. I had to unscrew the oven to go behind it because when one piece off of the element broke, it slide back behind the oven. I pushed the wire back thru the piece holes, connected the Element, and pushed the element with the wires back through the holes. I rescrewed t... read more

Oven wouldn't heat after cleaning cycle

  • Customer: Devin from Platte City MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 10 of 11 people found this instruction helpful
Turned power to oven off. Removed trim screws and trim. Removed screws that anchored oven in cabinet. Removed oven from cabinet. Removed back panel, tested thermal fuse. Determined it was defective, ordered new part and reversed procedures above to reinstall. read more