Models > RBD245PDQ1

RBD245PDQ1 Whirlpool Oven - Overview

Parts and Repair Help for models starting with RBD245PDQ1

If you know the oven repair part you need, you can browse the list of all parts for models starting with RBD245PDQ1, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for RBD245PDQ1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Models starting with RBD245PDQ1

$42.96

Bake Element

$2.70

Screw

This screw is sold individually.

$2.70

Screw

This screw is sold individually.

$5.54

Touch-Up Paint - White

$37.04

Thermal Overload Safety Thermostat

This part establishes and maintains the internal temperature of the oven cavity.

$24.55

Light Bulb - 120-130V - 15W

Sold individually.

$18.07

2 Piece Broiler Pan

$63.84

Temperature Sensor

This temperature sensor detects the temperature within the oven cavity.

$49.85

Broil Element

This broil element is found on the roof of the oven.

$40.91

Broil Element

This broil element is found on the roof of the oven.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

No heat after cleaning oven

  • Customer: Frederick from St. Louis MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 39 of 44 people found this instruction helpful
This built-in oven was slid out of it's space and set on a box. I removed the back cover with nut driver and located the safety overload device. removed nuts and used pliers to remove wires and replace them. The power must be off to do this repair.Replaced the cover and slid back into place. This could be a lot more difficult if your power cord or gas line ... read more

The circuit board shorted out

  • Customer: Bruce from Manassas VA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 55 of 97 people found this instruction helpful
The biggest challenge was figuring out how the panel was removed. Once I got that done, it was a piece of cake, just make sure that the connectors go back on the same slots on the new circuit board. read more

I broke the Bake Element while cleaning the oven.

  • Customer: Daniel from Cheraw SC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 19 of 21 people found this instruction helpful
I removed the two screws that held the bake element in place. Next I removed the Bake Element. I had to unscrew the oven to go behind it because when one piece off of the element broke, it slide back behind the oven. I pushed the wire back thru the piece holes, connected the Element, and pushed the element with the wires back through the holes. I rescrewed t... read more