Quick Question!

Have you ever purchased from PartSelect.com before?

Models > RBD245PDB15

RBD245PDB15 Whirlpool Wall Oven - Overview

Get Parts and Repair Help for RBD245PDB15

If you know the wall oven repair part you need, you can browse the list of all parts on the RBD245PDB15, or you can search by name or part description. You can also find your part by where it is located on the RBD245PDB15 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. We’ve also included any installation videos we have for RBD245PDB15 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.20

Touch-Up Paint - White

18ml

$11.07

Spray Paint - 12 oz. - White

$43.14

Oven Rack

Sold individually.

$6.60

Touch-up Paint - Black

16ml

$4.89

SCREW

Sold individually.

$6.70

Door Bumper - Black

Sold individually.

$20.81

Spray Paint - Surperior Black

This is a 12oz can of black spray paint.

$17.72

RETAINER

$7.11

Hinge Pin Kit

Includes 4 hinge pins. Used at hinges to hold door open so the door can be lifted off.

$38.14

VENT-OVEN

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

No heat after cleaning oven

  • Customer: Frederick from St. Louis, MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 83 of 91 people found this instruction helpful
This built-in oven was slid out of it's space and set on a box. I removed the back cover with nut driver and located the safety overload device. removed nuts and used pliers to remove wires and replace them. The power must be off to do this repair.Replaced the cover and slid back into place. This could be a lot more difficult if your power cord or gas line ... read more

I broke the Bake Element while cleaning the oven.

  • Customer: Daniel from Cheraw, SC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 38 of 46 people found this instruction helpful
I removed the two screws that held the bake element in place. Next I removed the Bake Element. I had to unscrew the oven to go behind it because when one piece off of the element broke, it slide back behind the oven. I pushed the wire back thru the piece holes, connected the Element, and pushed the element with the wires back through the holes. I rescrewed t... read more

Bottom Oven Element Wasn't Working

  • Customer: Shannon from Carlsbad, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 22 of 23 people found this instruction helpful
It was easy to remove the old element. It only required the removal of two screws and pulling apart the electric connectors. It was just as simple to install the new one. read more