Quick Question!

Have you ever purchased from PartSelect.com before?

Models > RBD245PDB10

RBD245PDB10 Whirlpool Wall Oven - Overview

Get Parts and Repair Help for RBD245PDB10

If you know the wall oven repair part you need, you can browse the list of all parts on the RBD245PDB10, or you can search by name or part description. You can also find your part by where it is located on the RBD245PDB10 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. We’ve also included any installation videos we have for RBD245PDB10 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$21.46

2 Piece Broiler Pan

The top of this part is now black.

$7.22

Touch-Up Paint - White

18ml

$11.07

Spray Paint - 12 oz. - White

$6.80

Touch-up Paint - Black

16ml

$4.94

SCREW

Sold individually.

$17.72

RETAINER

$7.11

Hinge Pin Kit

Includes 4 hinge pins. Used at hinges to hold door open so the door can be lifted off.

$20.80

Spray Paint - Surperior Black

This is a 12oz can of black spray paint.

$38.23

VENT-OVEN

$6.78

Door Bumper - Black

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

No heat after cleaning oven

  • Customer: Frederick from St. Louis, MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 82 of 90 people found this instruction helpful
This built-in oven was slid out of it's space and set on a box. I removed the back cover with nut driver and located the safety overload device. removed nuts and used pliers to remove wires and replace them. The power must be off to do this repair.Replaced the cover and slid back into place. This could be a lot more difficult if your power cord or gas line ... read more

The circuit board shorted out

  • Customer: Bruce from Manassas, VA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 72 of 133 people found this instruction helpful
The biggest challenge was figuring out how the panel was removed. Once I got that done, it was a piece of cake, just make sure that the connectors go back on the same slots on the new circuit board. read more

I broke the Bake Element while cleaning the oven.

  • Customer: Daniel from Cheraw, SC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 37 of 45 people found this instruction helpful
I removed the two screws that held the bake element in place. Next I removed the Bake Element. I had to unscrew the oven to go behind it because when one piece off of the element broke, it slide back behind the oven. I pushed the wire back thru the piece holes, connected the Element, and pushed the element with the wires back through the holes. I rescrewed t... read more