Models > RBD245PDB1 Whirlpool

RBD245PDB1 Whirlpool Oven - Overview

Get Parts and Repair Help for RBD245PDB1

If you know the oven repair part you need, you can browse the list of all parts on the RBD245PDB1, or you can search by name or part description. You can also find your part by where it is located on the RBD245PDB1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for RBD245PDB1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$45.67

Bake Element

$2.70

Screw

This screw is sold individually.

$19.30

2 Piece Broiler Pan

$40.91

Broil Element

This broil element is found on the roof of the oven.

$3.86

Touch-Up Paint - White

$38.37

Inner Oven Door Glass

$30.73

Oven Rack

$4.60

SCREW

$40.89

Door Hinge

Includes the coiled spring and can be used for either left or right side of appliance. Sold individually.

$2.70

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

I broke the Bake Element while cleaning the oven.

  • Customer: Daniel from Cheraw SC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 15 of 17 people found this instruction helpful
I removed the two screws that held the bake element in place. Next I removed the Bake Element. I had to unscrew the oven to go behind it because when one piece off of the element broke, it slide back behind the oven. I pushed the wire back thru the piece holes, connected the Element, and pushed the element with the wires back through the holes. I rescrewed t... read more

Digital control panel went haywire.. Control would not function

  • Customer: Anthony from Charlottesville VA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 9 of 10 people found this instruction helpful
First I removed the two screws that hold the sensor element in place (from inside the oven). I then pulled the sensor out about three inches and disconnected the two wires, and connected the new sensor. Screwed the sensor back into the back oven wall..

There was some confusion with the repair tech who first thought I would have to pull the pven o... read more

Inner glass

  • Customer: Michael from Denville NJ
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 11 of 16 people found this instruction helpful
Take door off completely by setting hinge locks into place and then removing door. Take all of the screws out from frame (remember that the flat screws go the outside and the raised heads on the inside of door)Remove the clips on the bottom of door as well. Carefully remove frame. Then remove the inner glass clips, this will allow you to remove the broke or ... read more