Models > RB787BB1BB

RB787BB1BB Hotpoint Range - Overview

Get Parts and Repair Help for RB787BB1BB

If you know the range repair part you need, you can browse the list of all parts on the RB787BB1BB, or you can search by name or part description. You can also find your part by where it is located on the RB787BB1BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for RB787BB1BB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the RB787BB1BB [Viewing 3 of 3]

$2.52

Light Bulb - 40W

Sold individually.

$22.41

Infinite Switch Kit

The infinite switch controls the stove top surface burner. This switch will work with most of the electrical range models with coil burner elements.

$38.62

Bake Element

This bake element has push-on wire terminals and the feet to keep it elevated from the bottom of the oven.

$83.91

Large Haliant Burner with Limiter - 8"

$5.77

Foot - Leveller

$38.45

Oven Rack

Sold individually.

$5.55

Oven Light Socket - With Push In Receptacle

$4.41

Light Cover

$16.87

Broiler Pan - Large

Includes the pan and grate.

$157.34

Electronic Clock Control

***NOTE: Wiring could be different from original and will possibly need to be installed by an appliance repairperson.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Bottom heat element

  • Customer: Alton from Marshall TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Pliers
  • 24 of 24 people found this instruction helpful
Turn the breaker off to the oven.Removed both wire racks,using a 1/4 nut driver unscrewed the old element.The flashlight was so I could see inside the oven.Having removed the two screws ,the old element came right out.With my needle nose pliers removed the wires one at a time,replacing them on the new element as they came off.Replaced the two screws holding ... read more

Large burner would not get hot

  • Customer: Kevin from Leominster MA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 27 of 36 people found this instruction helpful
Repair was very simple. Removed 2 screws under the cooktop, tilt the cooktop back, unplug 4 wires from 8" burner, remove two screws holding retaining clips, install new burner in reverse order. Very simple! read more

LOWER ELEMENT WAS NOT HEATING UP. INTERCHANGED TOP BROILER WITH LOWER ELEMENT TO CONFIRM THAT LOWER LEMENT WAS WORKING. POSTED PROBLEM ON FORUM. RECEIVED REPLY TO CHANGE OUT ELECTRIC CLOCK CONTROL. UPON DOING SO LOWER WAS BACK ON LINE. THANKS

  • Customer: JERRY from MEMPHIS TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 23 of 28 people found this instruction helpful
UPON REMOVING THE BACK PANEL OF RANGE WITH SCREWDRIVER TO GAIN ACCESS TO ELELCTRIC CLOCK CONTROL. UNIT WAS TAKEN OUT WITH THE USE OF A 1/4'' NUTDRIVER. AFTER FOLLOWING INCLUDED INSTRUCITONS WITH REPLACEMENT PART. PART WAS AN UNPLUGED/PLUGED IN OPERATION. WORKS GREAT. NO SERVICE TECHNICIAN NEEDED. THANKS GAIN. read more