Models > RB760PXBQ2

RB760PXBQ2 Whirlpool Oven - Overview

Get Parts and Repair Help for RB760PXBQ2

If you know the oven repair part you need, you can browse the list of all parts on the RB760PXBQ2, or you can search by name or part description. You can also find your part by where it is located on the RB760PXBQ2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for RB760PXBQ2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$28.25

Oven Temperature Sensor

This oven temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$5.25

Touch-Up Paint - White

$18.07

2 Piece Broiler Pan

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$41.79

Broil Element - 208V

This broil element is found on the roof of the oven and has push-on terminals.

$4.46

Light Gasket

$2.70

Screw

This screw is sold individually.

$29.31

SOCKT-LITE

$7.72

Spray Paint - 12 oz. - White

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 81 of 104 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

Socket Light had a bad thread

  • Customer: Edmund from Emporium PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 21 people found this instruction helpful
Socket Lite come with clips attached to the outside
of the housing. After you unhook the 3 lead wires
that are attached to the unit. All you have to do is push in on the clips and release the unit. Then you
snap in the new unit. Attach the 3 wire leads, put a
oven bulb in the socket end, and the install the light cover read more

Oven display error F1 Oven not functioning

  • Customer: Carmela from Tuckahoe NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 16 of 23 people found this instruction helpful
Secured circut breaker for range and began to remove rear panel w/screw driver. Revealed and removd 2 screws that secured existing control assembly. Installed new in kind and secured, then began very gently unplugging and reconnecting old to new. Task was done very slowing to insure that plugs were fastened correctly. When complete, energized breaker and a... read more