Models > RB757WB1

RB757WB1 Hotpoint Range - Overview

Get Parts and Repair Help for RB757WB1

If you know the range repair part you need, you can browse the list of all parts on the RB757WB1, or you can search by name or part description. You can also find your part by where it is located on the RB757WB1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for RB757WB1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$6.11

Drip Bowl - 6"

Sold individually.

$7.77

Drip Bowl - 8"

Sold individually.

$12.82

Surface Burner Terminal Block Kit

Also known as receptacle.

$40.04

Surface Burner Element - 8"

This Y-frame eight inch surface burner element has five turns and a metallic center medallion.

$22.41

Infinite Switch Kit

The infinite switch controls the stove top surface burner. This switch will work with most of the electrical range models with coil burner elements.

$41.36

Bake Element

This bake element has push-on wire terminals and the feet to keep it elevated from the bottom of the oven.

$34.29

Surface Burner Element - 6"

This Y-frame six inch surface burner element has four turns and a metallic center medallion.

$5.77

Foot - Leveller

$38.45

Oven Rack

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

BURNER BOWL NEEDED REPLACED

  • Customer: Stephen from Knoxville TN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 361 of 363 people found this instruction helpful
REMOVED BURNER ELEMENT AND PUT IN BOWL read more

The Bake-o-lite (Hard Plastic) block that holds the burners female connection in place had chipped away over time and wouldn't allow the male part of the burner to connect up correctly.

  • Customer: Robert from Mt. Vernon IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 64 of 66 people found this instruction helpful
After unplugging the range I took the rear sheet metal panel at the top off with a nut driver to expose the wiring connections. The next step was to remove the single screw holding the old part in place. (under the drip pan) Once free I snipped the old part from the wires and then taped the new female ends to the old wires with black electrical tape. From re... read more

couldn't find correct burner bowls anywhere

  • Customer: Sheril from Rockaway NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 77 of 141 people found this instruction helpful
very easy..pull out burner, slide new one in..like a plug.

none of the "replacement" burner bowls i found at
store like home depot/ bed bath and beyond and such didn't fit.. so much for universal sizing..

thank you parts select.

a very satisfied customer read more