Models > RB757BH2CT

RB757BH2CT Hotpoint Range - Overview

Get Parts and Repair Help for RB757BH2CT

If you know the range repair part you need, you can browse the list of all parts on the RB757BH2CT, or you can search by name or part description. You can also find your part by where it is located on the RB757BH2CT by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for RB757BH2CT parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the RB757BH2CT [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$6.11

Drip Bowl - 6"

Sold individually.

$7.77

Drip Bowl - 8"

Sold individually.

$60.66

Bake Element - Push On Terminals - 240V

The bake element is found on the bottom of the oven and has male spade terminals.

$11.25

Surface Burner Terminal Block Kit

This kit includes the female contact with wires, terminal block and mounting clip.

$12.82

Surface Burner Terminal Block Kit

Also known as receptacle.

$19.54

Surface Burner Switch - 8" - 2500W

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$39.65

Oven Rack

Sold individually.

$40.04

Surface Burner Element - 8"

This Y-frame eight inch surface burner element has five turns and a metallic center medallion.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

BURNER BOWL NEEDED REPLACED

  • Customer: Stephen from Knoxville TN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 361 of 363 people found this instruction helpful
REMOVED BURNER ELEMENT AND PUT IN BOWL read more

Lower bake Element would not heat.

  • Customer: Ronald from Nassau NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Pliers
  • 71 of 73 people found this instruction helpful
First I slid the stove out and unpluged it, then removed two screws,slid out element, disconected two wires, slid new element in to place, pluged two wires in ,put into place and installed two screws, pluged stove back in, and turned on to try. Works perfect. read more

The Bake-o-lite (Hard Plastic) block that holds the burners female connection in place had chipped away over time and wouldn't allow the male part of the burner to connect up correctly.

  • Customer: Robert from Mt. Vernon IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 64 of 66 people found this instruction helpful
After unplugging the range I took the rear sheet metal panel at the top off with a nut driver to expose the wiring connections. The next step was to remove the single screw holding the old part in place. (under the drip pan) Once free I snipped the old part from the wires and then taped the new female ends to the old wires with black electrical tape. From re... read more