Models > RB757BB1

RB757BB1 Hotpoint Range - Overview

Get Parts and Repair Help for RB757BB1

If you know the range repair part you need, you can browse the list of all parts on the RB757BB1, or you can search by name or part description. You can also find your part by where it is located on the RB757BB1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for RB757BB1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$12.60

Surface Burner Terminal Block Kit

Also known as receptacle.

$6.84

Burner Bowl - 8"

$5.98

Burner Bowl - 6"

$40.04

Surface Burner Element - 8"

This Y-frame eight inch surface burner element has five turns and a metallic center medallion.

$22.41

Infinite Switch Kit

The infinite switch controls the stove top surface burner. This switch will work with most of the electrical range models with coil burner elements.

$38.62

Bake Element

This bake element has push-on wire terminals and the feet to keep it elevated from the bottom of the oven.

$34.29

Surface Burner Element - 6"

This Y-frame six inch surface burner element has four turns and a metallic center medallion.

$5.77

Foot - Leveller

$38.45

Oven Rack

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The Bake-o-lite (Hard Plastic) block that holds the burners female connection in place had chipped away over time and wouldn't allow the male part of the burner to connect up correctly.

  • Customer: Robert from Mt. Vernon IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 65 of 67 people found this instruction helpful
After unplugging the range I took the rear sheet metal panel at the top off with a nut driver to expose the wiring connections. The next step was to remove the single screw holding the old part in place. (under the drip pan) Once free I snipped the old part from the wires and then taped the new female ends to the old wires with black electrical tape. From re... read more

Front burner would not heat up

  • Customer: Scott from Olathe KS
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 38 of 57 people found this instruction helpful
1. Pull out range and unplug from socket.
2. Lift range lid.
3. Remove back panel. Loosen the 6 - 1/4" nuts, then lift up slightly, which compresses the "latch" at the top middle. Let down and panel comes off easily.
(Note: Do not remove wires yet)
4. Remove control knob from front panel by pulling gently, exposing 2 small tap screwsread more

Bottom heat element

  • Customer: Alton from Marshall TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Pliers
  • 24 of 24 people found this instruction helpful
Turn the breaker off to the oven.Removed both wire racks,using a 1/4 nut driver unscrewed the old element.The flashlight was so I could see inside the oven.Having removed the two screws ,the old element came right out.With my needle nose pliers removed the wires one at a time,replacing them on the new element as they came off.Replaced the two screws holding ... read more