Quick Question!

Have you ever purchased from PartSelect.com before?

Models > RB184RDA (DG46A)

RB184RDA (DG46A) Admiral Refrigerator - Overview

Get Parts and Repair Help for RB184RDA

If you know the refrigerator repair part you need, you can browse the list of all parts on the RB184RDA, or you can search by name or part description. You can also find your part by where it is located on the RB184RDA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for RB184RDA parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the RB184RDA

[Viewing 1 of 1]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$8.01

Compression Nut - 5/16"

$17.87

DOOR- ICE

$20.55

Ice and Water Actuator Switch

This ice and water actuator switch is an inch long. It is black on one side and white on the other. This switch is made of plastic and has two metal prongs extending from its body.

$4.94

Screw

This screw is sold individually.

$64.67

Water Tank Kit with Unions

Ice Door Chute Insulation

This is part of the ice door chute and acts as a barrier (insulator) when the chute is not being used. It helps keep the ice cold once the ice cubes are conveyed from the container to the discharge opening.

Paddle Trim

Dispenser Grill

This dispenser grill is six and a half inches long, and is made of metal.

CLAMP- DRA

$17.79

SPRING- IC

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ice Dispenser had jammed up and become inoperative

  • Customer: James from Robinson, TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 31 of 38 people found this instruction helpful
The parts discription was a bit vague and I wasn't sure exactly what I was ordering, but I received everything I needed and it works fine. The combination screw conveyor/ice crusher came in one piece. The ice cube bin is a plastic assembly that snaps apart. I used a wide blade screw driver carefully to facilitate assembly/disassembly. Once you have it ap... read more

the ice/water actuator switch burnt out and was stuck on.

  • Customer: Jon from Nampa, ID
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 10 of 11 people found this instruction helpful
Removed the rubber cover over the actuator switch. Used a screwdriver to remove the switch, disconnected the wires. I then removed the switch from the mounting bracket using a small philips head screw driver. Installed the new switch on the mounting bracket then installed the switch onto the freezer door. The only difficult part was installing the rubbe... read more

The icemaker assebly would go off track

  • Customer: Donna from The Villages, FL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 5 of 5 people found this instruction helpful
I removed the front cover--just popped off with no trouble. Removed 2 screws at the bottom. Slid the broken part out and put the new one in place. Put in the two screws, replaced the fron cover AND Done!!!
BTW I am a 65 year old woman and the icemaker is like new. read more