RAX7245BW1 Roper Washer - Instructions

watched a utube vidieo and followed directions in repair kit poped the cap removed screw seperated agitator replaced worn parts reasembeled agitator simple

Found Website and entered model number. Used the quick explanation of problem to find required parts for repair. Found that one washer was left off in the parts recommended for repair while repairing that was purchased locally because it was cost was lower than part and shipping on line. The parts ordered from Part Select arrived with in 3 working days. Video was very helpful for the whole repair.

took broken agitator dogs out and put new parts in, it was very easy repair.

The most difficult part was aligning the two sides of the coupling. Disassembling the motor from the transmission was a snap. The replacement coupling was of higher quality than the original. It had metal bushings in the center holes, where they interface each driveshaft. The original did not. It was plastic.

It went very easy and the part was right very easy job to do saved a lot of money thanks to you thanks a lot

exactly like the instructions that came with the new parts said. they were very accurate.

The repair went very well as per the video, however the metal reinforced coupling only went onto the shaft half way. To ensure the coupling was flush with the top of the shaft I has to use a hammer and tamp the coupling onto the shafts. If you left it halfway on the shafts there was no room for the rubber spacer between the couplings. Other wise it operates very well.

Forget the instruction book, it's too time consuming and it's a knuckle buster. Disconnect all hoses and lay machine on it's back. (Have plenty of rags to soak up the half gallon of water still in the pump). Use pliers to slide back hose clamps on pump and slide off hoses. Use screw drive to snap off clamps holding pump in place. Remove pump. Simply reverse process to install new pump. It nearly was one of my wife's 5 minute jobs she always has on her "Honey Doo" list.

watched a video that showed how to repair that you had on your web site. also read some of the remarks that other people left on site, one was super easy. just laid washer on its back, unhooked both water lines from pump. unhooked both metal clips holding pump and pulled off. replaced new pump in reverse order. didn't have to go thru all the procedures of taking off the body or nothing. 15min job.

Replaced suspension, leveling and tub springs.

I followed the 'how to' video, stopping the video when needed to complete a portion of the repair. I was doing the repair in a laundry closet, which took me a little longer, but with the right parts ordered and the instruction video this project was easy and does not take very long.

Took agitator apart as shown in video, changed the agitator dogs, put agitator back together. Works great.

The washer breaks down slightly different than shown in the video. Install of the new part went pretty well. It was reinstalling the washer cover that caused most of the grief. You have to have all of that sheet metal lined up just right or it won't go back together. All good now...very happy.

The replacement part was "perfect" and the parts dept. lady I spoke with, was professional in description and correctly fitting part. The part arrived, we popped off the other where it would have fit, then the "collar" below it, put on the new collar, the dial and we were done. Before that, we'd been using a pair of pliers to move the dial around to do the laundry. This was an easy experience, quick upon arrival and we we're pleased with the purchase and how nice it is to have a working appliance again.

I followed the helpful video from PartSelect. Removal and Replacement of the Clutch Assembly was fairly easy. Just make sure you have enough towels to dry up any water that may come out after tipping the washing machine over. After Replacement the washing machine works like new. Thanks PartSelect.