Models > RAX4232KQ0 > Parts

RAX4232KQ0 Roper Washer - Parts

All parts for the Roper Washer RAX4232KQ0

Below is a list of all parts for the Roper Washer RAX4232KQ0 - Residential . To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the RAX4232KQ0
43-56 of 204
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Spanner Nut

Right hand threaded nut holds the tub in place in direct drive, top loading washing machines. To remove the spanner nut you will need a spanner wrench.


Hose Clamp

This clamp helps to prevent leaking by holding the end of water hose in place.


Lid Hinge Bearing

This is the bearing for the lid hinge. Sold individually.


Inner Tub Filter Plug Kit

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.


Touch-Up Paint - .6fl Ounce - Biscuit


Centerpost Bearing and Seal Assembly

This assembly comes with two center post bearings and two seals, and three agitator shaft seals.


Motor Capacitor

This part gets the motor up to speed quickly before transferring power to the run capacitor.


Rear Leveling Foot

Sold Individually. Used to help stabilize the appliance on uneven surfaces.


Spring Outer Bracket


Main Top Clip


Balance Ring Clip

Sold individually. Order quantity required.


Siphon Break Kit

This six piece washing machine syphon break kit for is intended for use with plastic drain hoses. Use this kit with your Whirlpool/Kenmore brand washing machine.


Spin Tube "T" Bearing


Sound Deadening Ring

Located in the clutch housing, this ring is used only to muffle any sound.

All Parts for the RAX4232KQ0
43-56 of 204