Models > PYET444AZW

PYET444AZW Maytag Dryer - Overview

Get Parts and Repair Help for PYET444AZW

If you know the dryer repair part you need, you can browse the list of all parts on the PYET444AZW, or you can search by name or part description. You can also find your part by where it is located on the PYET444AZW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for PYET444AZW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$14.08

Multi Rib Belt - 92-1/4"

This dryer drum belt has four ridges, three grooves and is 1/4" wide.

$10.77

Door Catch Kit

This kit comes in two pieces: the catch and the clip.

$14.06

Lint Filter

This lint filter screen has two side guides on either side of the screen. One measures 3/8 of an inch wide, while the other measures 5/8 of an inch wide.

$37.91

Rear Drum Support Roller Kit

Included in this rear drum support roller kit are 4 screws, 1 spacers, 2 washers, 2 retaining rings, 2 rear rollers, and 2 cylinder support shafts. *** Note: Per manufacturer this kit has been updated now to have one spacer that is the thickness of 2 spacers. To get these parts separately, please search by model#.

$2.70

Blower Wheel Clamp

$36.29

Blower Wheel

This wheel has a deep D-shaped shaft receptacle. The spring clamp is not included with this part.

$2.70

Screw

This screw is sold individually.

$2.70

SCREW

This screw is sold individually.

$18.07

Moisture Sensor

This part helps determines the dryness of the clothes to reduce over-drying.

$15.20

Drum Felt Seal

Depending upon your model, this seal can be used on either the front or rear drum. The hi-temp adhesive is sold separately.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

broken lint filter

  • Customer: BRUCE from SAN MARCOS CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 120 of 191 people found this instruction helpful
First went and got a beer.
Looked at the dryer.
Drank my beer.
Went and got one more, due to long job.
Looked at dryer again.
Opened the door.
Had to get one more beer.
Removed filter.
Got one more cold one.
Put new filter in.
Got one more beer.
Closed door.
Finished! read more

broken tumbler belt

  • Customer: Michael from San Antonio TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Wrench set
  • 73 of 74 people found this instruction helpful
1. Removed the screws from the lint catcher
2. Removed the bolts from upper rear of dryer
3. Pried off the dryer top from the front (it rests on rear hinges)
4. Disconnected dryer door wiring
5. Removed bolt from inside upper front corners; removed front panel (be careful: the edges are sharp and the tumbler will fall when it loses suppor... read more

Lint Filter Broke

  • Customer: Timothy from Cheektowaga NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 65 of 65 people found this instruction helpful
I slid in the new one read more