Quick Question!

Have you ever purchased from PartSelect.com before?

Models > PSS26MSWASS > Parts

PSS26MSWASS General Electric Refrigerator - Parts

All parts for the General Electric Refrigerator PSS26MSWASS

Below is a list of all parts for the General Electric Refrigerator PSS26MSWASS - W Series. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the PSS26MSWASS
1-14 of 268
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$10.98

Temperature Sensor

This temperature sensor, also known as a thermistor, is used for refrigerators and freezers. The sensor sends the temperature reading of the refrigerator towards the control board....

$2.67

Evaporator Fan Grommet - Red

If you notice that your refrigerator or freezer is noisy or too warm, you may need to replace the evaporator fan grommet. This part is red in color, and is about 1 inch in diameter. The evaporator fan grommet is located behind the evaporator fan cover in the back of the freezer. You will need to remove the evaporator fan cover to access the evaporator fan and complete this repair. Before you begin this repair, ensure the power to the refrigerator is disconnected. You will need a pair of needle nose pliers, a small flat blade screw driver and both a 1/4 and 5/16-inch nut drivers to complete this repair.

$18.45

Module Shelf Insert

This part is located in the front of the module shelf.

$7.36

Dispenser Door Assembly or Flapper

The dispenser door assembly (or flapper) is what opens to release the ice once the lever has been pressed. This part mounts in the ice dispenser. The cranker no longer comes with this part. You can use the original crank. The crank is sold separately depending on the model number of the appliance. For this repair, all you will need is a Phillips screw driver and a small flat blade. Disconnect the power, remove the escutcheon from around the dispenser, lift up the control panel, disconnect all wire connectors, use a screwdriver to remove all four screws of the housing, and lift the housing out. You will now see the flapper: push the tabs that are securing it in place to remove the piece, install the new flapper by lining it up and snapping into place.

$41.11

Dispenser Door Solenoid Assembly

This part is a possible option when ice door won't open or shut properly or when water is not dispensing.

$62.40

Defrost Heater and Bracket Assembly

The defrost heater keeps the cooling coils from frosting over. The heater will get hot and melt any ice or frost build up around the coils.

$31.25

Condenser Fan Motor

This fan motor is most times used with frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, ...

$26.87

Water Tank Assembly

This tank stores water until the water actuator is activated and water is requested.

$3.50

Evaporator/Condensor Fan Grommet

$3.42

Recess Door Spring

$31.10

Ice Dispensing Drive Cup

This part is found at the end of the auger in the ice container - replace this part when the icemaker doesn't dispense ice.

$4.07

Light Switch

$1.87

Compression Ring

This compression ring is meant to hold the evaporator fan motor in place in the freezer compartment of your refrigerator. This is is a genuine OEM part. The tools needed to complet...

$12.30

Handle/Front

For freezer baskets.

All Parts for the PSS26MSWASS
1-14 of 268