Models > PRG3601P

PRG3601P Jenn-Air Range - Overview

Get Parts and Repair Help for PRG3601P

If you know the range repair part you need, you can browse the list of all parts on the PRG3601P, or you can search by name or part description. You can also find your part by where it is located on the PRG3601P by selecting a section below. We’ve also included any installation videos we have for PRG3601P parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Screw

This screw is sold individually.

$18.07

2 Piece Broiler Pan

$36.89

Oven Light

RECEPTACLE

$235.48

Glow Bar Oven Igniter - Rear

This part is used to light the oven.

$38.13

KIT- BURNE

$4.60

Screw (4)

KNOB- THER

$36.27

SWTCH-LITE

$2.92

Hinge Screw

Sold Individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

hard to get old one out

  • Customer: robert from chatham VA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 15 of 37 people found this instruction helpful
easy to put in read more

needed new oven light assembly/part #PS1864256

  • Customer: Sara from Harwich Port MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 15 of 48 people found this instruction helpful
Removed old assembly, attached wires to new and inserted into space for same. Of course you must turn off the range circuit breaker. The part that took the most time was removing the old assembly. Once that was done, the rest took only a few minutes. read more

oven light replacement

  • Customer: martin from portland OR
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
bought used, oven light was damaged from previous repair attempt, without installation instructions removing the fixture was tricky, had to bend the housing tabs inward w/screwdriver to release fixture (more damage). once out the new fixture went in place quite easily, wires simply hook up, re install back panel, re-connect power, Have a nice Day! read more