Models > PR437K1

PR437K1 Hotpoint Cooktop - Overview

Get Parts and Repair Help for PR437K1

If you know the cooktop repair part you need, you can browse the list of all parts on the PR437K1, or you can search by name or part description. You can also find your part by where it is located on the PR437K1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the PR437K1 [Viewing 1 of 1]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.36

Single Screw Only

Sold Individually.

$2.79

Screw

Sold Individually.

$120.87

Element Disc

DISCONTINUED

$2.36

SCREW

$206.73

THERMAL SWITCH

$2.14

HEX NUT

$1.27

NUT

$96.96

INF HT SW

$112.12

"DISC ELE-9"" "

Common Symptoms of the PR437K1 [Viewing 1 of 1]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Large burner very slow heating

  • Customer: Drusilla from Bloomfield NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 3 of 5 people found this instruction helpful
Downdraft stove is over 20 years old, but everything else works fine and it would be a real pain to replace it.

This quick-heat back burner is part of a two burner plug- in unit which takes up half of the top of the stove.

I removed the top from the rest of the unit easily removing five screws. Because of the age and long use it was to... read more

Electric cooktop burner would not heat

  • Customer: Donald from Gunnison CO
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 2 of 4 people found this instruction helpful
Disconnect power to burner module. Dissassemble module with nut driver. Screws connecting feed wires to burner were too corroded to remove. Cut wire close to screws, stripped insulation and inserted new ends into new burner. Reassembled module with nut drivers. read more

Solid large burner element wouldn't heat

  • Customer: Roger from Reedville VA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 1 of 2 people found this instruction helpful
This burner element is the large element of a 2 element modual.
After removing the modual, there was 6 small metal screws to open the modual to expose the burner elements. After the burner element were exposed there are 2 wires that had to be disconected with a screw driver. Once the wires are disconnecter the burner element is easy removed by sliding t... read more