Models > PR230K1

PR230K1 Hotpoint Cooktop - Overview

Get Parts and Repair Help for PR230K1

If you know the cooktop repair part you need, you can browse the list of all parts on the PR230K1, or you can search by name or part description. You can also find your part by where it is located on the PR230K1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for PR230K1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the PR230K1 [Viewing 1 of 1]

$30.05

Surface Element - 8" - 2350W

$21.91

Surface Element - 6" - 240V

This Y-frame six inch surface burner element has five turns and a metallic center medallion.

$2.36

Single Screw Only

Sold Individually.

$40.76

Surface Burner Terminal Block Kit

This kit comes with the terminal block, mounting clip and wires.

$3.76

Terminal Block Clip

$76.66

Infinite Control Switch - 8"

$53.39

Maintop Seal - Gray

This part is located under the control panel.

$30.55

Infinite Switch Burner Knob

Sold Individually. This knob accepts a double-flat shaft.

$79.66

Surface Burner Switch - 6"

$2.79

"SCREW-6-32T 6-20 X 3/8"

Common Symptoms of the PR230K1 [Viewing 1 of 857]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replacement of Coils

  • Customer: Joseph from South Plainfield NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 31 of 37 people found this instruction helpful
Removed by slightly wiggling out of the coupling. No tools needed, seriously, (and I'm a contractor). Basically, pull out and snap back in. read more

There was no heat on the coils.

  • Customer: Shaohui from East Lansing MI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers
  • 22 of 24 people found this instruction helpful
I opened the lid, and found that the terminal blocks were burnt, the wires were melted. I ordered one set of terminal block to replace the burnt one, and it worked. Before I started, I shut off the electricity in the whole house to be safe. read more

Surface burner coil did not work.

  • Customer: Gregory from Mont Belvieu TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 14 of 17 people found this instruction helpful
TURN OFF ALL POWER TO KITCHEN. Took off all burner coils and plates below them. Lift hood. Locate part. Remove old part and replace with new part in same way as was previously installed. The wire that comes with the kit is actually too much wire, but just arrange it the best you can and leave it....no big deal. I didn't have a magnet, but needed one. T... read more