Models > PLD4375RFC0

PLD4375RFC0 Frigidaire Dishwasher - Overview

Get Parts and Repair Help for PLD4375RFC0

If you know the dishwasher repair part you need, you can browse the list of all parts on the PLD4375RFC0, or you can search by name or part description. You can also find your part by where it is located on the PLD4375RFC0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for PLD4375RFC0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$11.18

Upper Spray Arm

This part is located on the top of the tub.

$12.98

Bottom Gasket

This gasket goes on the bottom of the dishwasher door. Note: Once the gasket is replaced and you continue to have water around the bottom corners of the door panel, you may need to order the splash shield kit.

$10.40

Tub Gasket

The gasket provides a waterproof seal between the tub and the door.

$3.27

Heating Element Brass Nut

This nut is sold individually. It is used to install the heating element.

$43.18

Drain Pump

The pump ejects the water from the unit.

$52.57

Middle Spray Arm - Gray

$28.39

Delivery Tube Gasket

Sold individually.

$16.98

Friction Door Cable

Sold individually.

$16.73

Lower Rack Wheel with Clip

Sold individually. Order quantity required.

$20.27

Cover and Stem Assembly

This plastic cover and stem assembly helps hold the lower spray arm in place.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The spray arm would fall off during the washing cycle.

  • Customer: Roy from Worcester MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 392 of 396 people found this instruction helpful
Repair was simple. I unscrewed the old grommet which held the old spray arm and screwed-on the new one. About 30 seconds was required. Other people having this problem should note that the spray-arm is made of three pieces which are inseparable when the arm is new. The arm is sold in this form. However, when your machine is having the problem that the a... read more

Bottom Door Seal fell apart and started leaking.

  • Customer: Scott from Flowood MS
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 66 of 76 people found this instruction helpful
First I opened the door all the way. Second I reached down to the bottom gasket then grabed it on the right end of the seal that is on the right side of the door. Then I pulled the end outward from the bottom of the door toward the heater coil in the bottom of the washer. It came out real easy. You see it just snaps into a little plastic groove under the doo... read more

Upper spray arm had been "blowing off" during wash cycle.

  • Customer: Mary from Alexandria VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 48 of 55 people found this instruction helpful
Unscrewed retaining ring, replaced unit = piece of cake read more