Models > PDW9280L00SS > Instructions

PDW9280L00SS General Electric Dishwasher - Instructions

All installation instructions for PDW9280L00SS parts

These instructions have been submitted by other PartSelect customers and can help guide you through the dishwasher repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the PDW9280L00SS
271-277 of 277
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

tear in the tub gasket

  • Customer: Edward from Granite Bay CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Pulled out the old gasket and replaced with the new gasket. Inserted the steel spring clip into the ends of the gasket. Repair complete.

Original Lower Basket Wheels or Axle Broke

  • Customer: Stephen from Ottumwa IA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Remove empty basket from dishwasher. Place basket, flipped over, on a flat surface. Pre-insert axle onto wheel before attaching to basket. Snap assembled axle and wheel onto the support pin. Replace in Dishwasher. PartSelect provided outstanding Customer Service!

wheels kept falling off

  • Customer: April from Port Deposit MD
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
just replaced old wheels and pin to attach wheels. very easy.

All 8 wheels had melted & we're falling off constantly! Very frustrating!!!

  • Customer: Meri from Sammamish WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Removed old wheels & axels, replaced with new ones ordered. So simple.

water leak left side of door bottom intermittent

  • Customer: Gary from Willoughby OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
Remove door cover shell by removing screws in inside of door. Unplug harness to control module.Remove outer door shell.Remove four screws at the blower motor. Replace with new motor after disconnecting harness to motor. Reinstall module harness reinstall door shell.

tray wheels wobbly, kept fallin off tray rack

  • Customer: Roman from Florham Park NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
ordered "stud roller part", basically an axle for the wheel which clips on to the tray rack. Simply removed the old clip from each wheel, placed new clip on wheel (had to use a hammer to snap it in place), then cliped it to rack by hand. very easy solution. Tray rack rolls perfectly and me wife is very happy.

Our tub gasket was torn by leaning utensils (a definite design flaw.)

  • Customer: Frances from Goodyear AZ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Just have a good look at how the original is installed before removing, then clean the area. The new one was a breeze to install, just line it up and pop it in.
All Instructions for the PDW9280L00SS
271-277 of 277