Models > PDBL390AWW

PDBL390AWW Maytag Dishwasher - Overview

Get Parts and Repair Help for PDBL390AWW

If you know the dishwasher repair part you need, you can browse the list of all parts on the PDBL390AWW, or you can search by name or part description. You can also find your part by where it is located on the PDBL390AWW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for PDBL390AWW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$26.31

Door Handle and Latch Assembly with Switches

This part includes the white handle, door latch and 2 switches. This part is a simple on/off mechanism that prohibits the dishwasher from operating when the door is open.

$3.71

Lower Wheel Assembly

Sold individually.

$22.09

Inner Door Foam Insulation Strip

Helps prevent leaking from the door area.

$65.72

Accumulator Filter

This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.

$47.45

Door Seal

It provides a waterproof seal between the tub and the door.

$2.70

Hose Clamp

$25.09

Door Latch with Switches - NO Handle

This is the door latch and switches only. The handle is not included with this part.

$16.95

Wash Impeller

This impeller rotates and is used to force water up through to the spray arm.

$21.09

Docking Station with Flappers

The docking station is located on the water supply tube at the far back. It provides water to the upper and middle spray arm and also includes the flappers.

$3.86

Door Cable Link

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broken latch handle

  • Customer: Walter from Tucson AZ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 518 of 518 people found this instruction helpful
The hardest thing was figuring out that you only need to purchase the latch handle because it only comes as a complete latch assembly, why they even list the latch assembly as a separate part in the parts list stupid. (you get the handle and latch already put together and it cost less than the latch assembly without the handle). Anyway all you need to do is ... read more

Door release latch handle was broken. The handle was deeply recessed into the door and the door was difficult to open.

  • Customer: Dave from Livonia MI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 470 of 468 people found this instruction helpful
Remove the 8 or 9 torx screws holding the inner and outer door assembly together (leave the bottom screws in), lift the old handle assembly out, transfer the switches to the new handle assembly, and reassemble door. read more

door would not open

  • Customer: jeff from strongsville OH
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 375 of 376 people found this instruction helpful
remove torq scew from edge of inside of door and seperate plastic inner panel from out steel and then pull up on plastci unscrew 2 screw securing handle and reverse to assemble. Anyone can door this in under 10 mins. read more