NAV3335AWW Amana Washer - Instructions

1. Open washer lid.
2. Remove right hinge mounting screw by leaning agitator/tub assembly to the right.
Do the opposite for the left hinge mounting screw.
3. Remove and replace both hinge pins on the lid.
4. Install both hinges on the pins and install lid back on the washer.

got the right part great service from partselect invited my bro in law 20 mins we where done.. no more violent shaking spin cycle thank you very much

Disassembled washer as per directions with seal kit. Removed inner tub. Cut both tub shaft bearing in half; punched out from outter tub. Installed new bearings using .5 inch threaded rod, washer and bolts. Installed new seal on inner tub shaft. Installed inner tube. Re-assembled washer.

I turned washer over, took off old shredded belt. One of the pulleys is spring loaded so I just held it in as i looped the new belt on. Easiest repair I have made on a washer!

We're not repair people. So when calling around for the replacement belt no one had it. Everyone said that the belt went to a dryer. We simply inspected the machine. Located the worn belt which was on the bottom of the washer machine went online and ordered the belt. Thank you so much you guys really saved me. I will always recommend you all to everyone that I know. Your system works Great! Thanks Part Select!

found your web site and the helpful hints Thank you it works wonderful even washing heavy loads

Remove one screw, deep inside the auger, (used a 10" extension on my power drill to bolt off and bolt on the new part. Snap its done.

Popped the cap unscrewed the old part slid in the new replaced the bolt and we were back in business.

Awesome service I had the part before a repair person could make a house call. Also I have a home warranty and this route ended up being 5 dollars cheaper :) Cheaper and faster gotta love it.

Pulled the washer away from the wall, tilted it 45' pulled belt off loosened the bolt on the motor belt tensioner & installed new belt.

Just un-bolted old agitator and bolted on new one with a socket wrench and an extender. Just that simple.

Replaced water in-flow valve it's fixed! Removing the washer case to replace the part would have been the most painful job of all. I used dremel cutter to cut a hole in the back panel to access to the valve rather than trying to figure out how to remove the washer case! It works fine! Part was delivered in time. Thanks!

The repair was very simple. We got the part faster than we thought we would had our son hold the washer on a tilt and put on the drive belt, took 2 times because it was twisted but we got on. The washer is much quieter and it was worth the shipping fee.

I used Utube to search for Performa Washing machine jumping around. You will find several videos that will be extreamly helpful in understanding exactly how to go about changing the sunbber ring. The snubber ring is fairly easy to change out. Quarters were used to hold the springs apart so they can be removed. Push the tub forward and away from the spring you want to remove. Install several quarters in the spring. Use as many as you can get in. Then pull the tub toward you and the spring can be removed from the tub. There are six springs to remove. I just left them laying in place at the bottom of the washing machine base. There are videos on utube also of using the quarters to remove the springs. Of course if you have spring removal tool for this purpose so much the better. I didn't have one. Good luck with your install. MB in TN

Used the testimonial found on your web site. Pulled off top flipped machine on its back removed springs from tub. Once tub removed loosened square drive nuts part way until snubber ring could be removed. Installed new ring and reassembled. To install agitator be removing bolt inside broken agitator auger. Easy to do saved alot of $$$ by doing myself. Thanks!!

Just like your video explained