Models > MQU1656BEW

MQU1656BEW Maytag Freezer - Overview

Get Parts and Repair Help for MQU1656BEW

If you know the freezer repair part you need, you can browse the list of all parts on the MQU1656BEW, or you can search by name or part description. You can also find your part by where it is located on the MQU1656BEW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your freezer. We’ve also included any installation videos we have for MQU1656BEW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$6.98

Light Rocker Switch

$3.82

FAN BLADE AND CLIP ASSY

$2.70

Cabinet Mount Screw

Sold Individually - 2 screws needed to mount each handle.

$50.06

TIMER-DEF

$126.37

Evaporator Fan Motor

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

$3.82

VENT-PLUG

$2.70

Screw

This screw is sold individually.

$3.82

Screw - 8-18 x 1/2

Sold individually.

$23.61

Overload

Relay is NOT included.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Lights inside refrigerator not working

  • Customer: Clint from Rayville MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 41 of 49 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

Froze over fan motor burnt out

  • Customer: James L. from Madison AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 29 of 31 people found this instruction helpful
Removed shelves from inside freezer then removed 4 screws holding cover panel. Pulled panel up and slightly pulled forward to remove. Removed wiring connections then removed two screws that held the motor & fan assembly. Removed the support bracket from the old motor and installed same on the support bracket. Reversed removal procedures for installation.... read more

Evaporator fan did not run

  • Customer: Murray from Terrebonne OR
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 15 of 17 people found this instruction helpful
The first thing I observed was the bolts that attach the motor to the mounting bracket were installed backwards at the factory. This caused the fan to catch on the bolt ends which resulted in the motor burning up. When I installed the new motor, I reversed the bolt direction. There is no way the fan will catch. The freezer works great ! read more