Quick Question!

Have you ever purchased from PartSelect.com before?

Models > MMV5207AAB

MMV5207AAB Maytag Microwave - Overview

Get Parts and Repair Help for MMV5207AAB

If you know the microwave repair part you need, you can browse the list of all parts on the MMV5207AAB, or you can search by name or part description. You can also find your part by where it is located on the MMV5207AAB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for MMV5207AAB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.50

Light Bulb - 40W

The 40W lightbulb is found in the interior of your microwave, which will need to be replaced if you have noticed the light is no longer coming on after opening the door. The light ...

$9.32

Air Filter

This is a microwave air filter that is located on the bottom side of an over-the-range appliance. No tools are needed for this repair, simply pull back on the tab to lift the existing filter out, and replace with new filter. This air filter is eight inches long, 5 inches tall, and is made entirely of metal. This is an OEM part that is sourced from the authentic manufacturer of the appliance. To preserve the life of your microwave air filter, occasionally take it out and wash it in a warm water and detergent solution.

$14.82

Black Sleeve Diode

In your microwave, the diode allows current to flow one-way only, converting alternating current to direct current. If you notice that your microwave does not heat properly, you ma...

$15.86

Charcoal Filter

$21.27

Halogen Lamp

$52.44

Door Interlock Switch Kit

This part is a genuine manufacturer door interlock switch kit, also known as primary micro switch or microwave switch kit, for a microwave. The function of this part is to sense when the door of the microwave is open or closed. If the part is defective, the microwave will not start or will start when door is open. This kit contains two 15 Amp, 125/250 Volt switches with 3/16 inch terminals. Be sure to disconnect power to microwave before replacing part. Use extreme caution when replacing microwave parts, as high-voltage capacitors can retain an electrical charge when unplugged.

$4.62

Wave Guide Rivet

This rivet is used for the stirrer cover/wave guide. They are sold individually.

$3.00

Screw

$4.79

Screw

Sold individually.

$53.50

Turntable Motor

This motor rotates the glass turntable in the microwave.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave worked intermittently depending on how door was closed

  • Customer: Robert from Bainbridge Island, WA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 61 of 70 people found this instruction helpful
Remove top grille (2 screws), undo control panel (1 screw). Tilt down control panel, switches are on the left. There are actually three switches that are involved with the door, two horizontally mounted, one vertically mounted. This would be an EASY REPAIR, but it took me a while to figure out which of the three switches was bad, and also took a while to ... read more

loud buzzing noise

  • Customer: Sandra from coto de caza, CA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 46 of 86 people found this instruction helpful
The repair went well...I am so glad that I read this info before buying a new microwave....it saved me lots of money. I did have a repair man come and look at it and he told me to buy a new one but it cost alot of money when it wasn't necessary. I did the repair and I was very proud of myself.
Three men watched a woman fix this and it was no problem...... read more

burned out bulb

  • Customer: john from plainfield, IL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 19 of 26 people found this instruction helpful
removed two screws,lowered the glass shield,removed the burned out bulb and replaced it with the new one. I ordered the bulb from parts select and recieved it two days later. It was a pleasure to deal with them, and certainly use them again. read more