Models > MMV5165AAQ

MMV5165AAQ Maytag Microwave - Overview

Get Parts and Repair Help for MMV5165AAQ

If you know the microwave repair part you need, you can browse the list of all parts on the MMV5165AAQ, or you can search by name or part description. You can also find your part by where it is located on the MMV5165AAQ by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for MMV5165AAQ parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.54

Light Bulb - 40W

Sold Individually.

$2.70

SCREW

Sold individually.

$5.71

Light Bulb - 120V 25W

Sold individually.

$10.30

Air Filter

Sold individually.

$12.05

Black Sleeve Diode

$4.02

Wave Guide Rivet

This rivet is used for the stirrer cover/wave guide. They are sold individually.

$15.55

Charcoal Filter

$45.16

Door Interlock Switch Kit

This kit contains 2 switches - 15 Amp - 125/250 Volt with 3/16" terminals.

$2.70

SCREW

$2.70

Cabinet Screw

This screw is sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Sparks and loud hum from oven

  • Customer: Guy from Bellingham MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 59 of 95 people found this instruction helpful
1. I went to the internet to find the service manual for the Maytag microwave.
2. I opened up the oven and started measuring the resistance of the diode, capacitor, transformer, and magnetron between terminals and then to ground. The transformer and magnetron were well within the resistance limits. The diode was shorted in both directions(+-). The capac... read more

Microwave worked intermittently depending on how door was closed

  • Customer: Robert from Bainbridge Island WA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 36 of 43 people found this instruction helpful
Remove top grille (2 screws), undo control panel (1 screw). Tilt down control panel, switches are on the left. There are actually three switches that are involved with the door, two horizontally mounted, one vertically mounted. This would be an EASY REPAIR, but it took me a while to figure out which of the three switches was bad, and also took a while to ... read more

burned out bulb

  • Customer: john from plainfield IL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 13 of 18 people found this instruction helpful
removed two screws,lowered the glass shield,removed the burned out bulb and replaced it with the new one. I ordered the bulb from parts select and recieved it two days later. It was a pleasure to deal with them, and certainly use them again. read more