Models > MMC5193AAW

MMC5193AAW Maytag Microwave - Overview

Get Parts and Repair Help for MMC5193AAW

If you know the microwave repair part you need, you can browse the list of all parts on the MMC5193AAW, or you can search by name or part description. You can also find your part by where it is located on the MMC5193AAW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.


Black Sleeve Diode


Ceramic Fuse - 20 Amp

This ceramic microwave fuse is white in the center, while each end is made of metal. This is a twenty amp fuse.


Light Bulb

Sold individually.















Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

microwave oven blew fuse

  • Customer: tad from tamarack MN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 16 of 22 people found this instruction helpful
First I removed upper front grill by removing two Philips head screws on top and pulling off. This exposed the Philips head screw which holds control panel in place. After removing screw I pushed up on panel and it came off to expose fuse. With needle nose pliers I removed old fuse and again with pliers held new fuse in position. With the help of a bladed s... read more

interior lamp burnt out

  • Customer: leverett from villa ridge MO
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 9 of 15 people found this instruction helpful
remove outer cover of microwave, (special recessed star bit required) change bulb, unplug and remove 1 phillips screw. read more

Light bulb burned out.

  • Customer: Stephen from Cottonwood AZ
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 7 of 11 people found this instruction helpful
Found instruction on internet,
1. Remove anit-tampering screws with punch and hammer
2. Remove the rest of the screws
3. Removed cover
4. Remove burned out bulb and installed new one
5. INstalled cover
6. Installed screws including the anti tampering onces
7. Op tested unit.
Wife is happy. read more