Quick Question!

Have you ever purchased from PartSelect.com before?

Models > MLE2000AYW > Parts

MLE2000AYW Maytag Washer Dryer Combo - Parts

All parts for the Maytag Washer Dryer Combo MLE2000AYW

Below is a list of all parts for the Maytag Washer Dryer Combo MLE2000AYW. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the MLE2000AYW
29-42 of 382
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$4.48

Timer Knob Insert Cap

This timer knob insert cap is just over two inches in diameter. It is all white in color and is made of plastic.

$59.20

Lip Seal Kit

This kit comes with grease, earlier lip seal, revised lip seal, o-ring, seal tool, and washer kit. Used primarily on front load washers. NOTE: Bearing is NOT sold separately. It is only available with the outer tub assembly.

$23.55

Blower Wheel

This blower wheel does not come with a spring clamp, but it does have twenty fins and it is designed to fit a 3/8 of an inch motor shaft.

$22.41

Thermal Fuse

This thermal fuse is mounted on either the heating element or burner tube housing.

$5.51

Hose Clamp

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washe...

$139.44

Drive Motor - 115V

This part has a D-shaped motor shaft and this motor runs at 1/4 horsepower and carries 4.5 amps.

$3.57

Idler Spring with Rubber Dampener

$122.73

Drain Pump - 120V 60Hz

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

$3.02

Screw

Sold Individually.

$17.56

Wax Motor

This wax motor is just over two inches long. It is used on some older style washing machines.

$8.22

Terminal Block

This terminal block assembly does not come with any hardware. It it three inches long and made of plastic and metal.

$138.59

Heating Element - 240V

The dryer heating element provides the heat needed to dry your clothing during a cycle. The part consists of a metal tube with a coil inside. It carries a 240 voltage, and is almost 15 inches long with a diameter of approximately seven inches. The heating element comes with a thermal fuse and a heat shield. You will need a Phillips screwdriver, a 1/4-inch nut driver, a 5/16 nut driver, and a pair of needle nose pliers to replace your heating element.

$5.10

Screw, 8/18 x 3/8

This screw is sold individually.

$4.48

Inlet Hose Washer

This inlet hose washer, also known as a high pressure inlet hose washer, is used in washing machines, refrigerators, freezers, and dishwashers. The function of this part is to create a watertight seal in the appliance. If your gasket gets dry and brittle over time it will start to crack and will lose its function. In this case, it is important to replace it. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance. As a safety precaution, remember to unplug your washer from the power source before beginning.

All Parts for the MLE2000AYW
29-42 of 382