Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
Below is a list of all parts for the Maytag Washer Dryer Combo MLE2000AYW. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.
This drum support roller includes one drum roller and two bearings. Most dryers use two drum rollers, and is recommended to change both at once.
This front glide kit comes with a blue plastic glide, a brown cork pad, and two metallic rivets. Two kits are required per appliance. Also, a rivet tool is required for this kit - purchase locally.
Also known as the door boot seal. This part includes the drain and plug. The seal is located around the door of the washer to prevent water from leaking.
This part replaces older two terminal switches.
This kit contains a flat drive belt, two motor isolators, and an instructions sheet. The drive belt is made to slip on the pulley until the basket gets up the desired speed.
This kit comes with grease, earlier lip seal, revised lip seal, o-ring, seal tool, and washer kit.
Used primarily on front load washers.
NOTE: Bearing is NOT sold separately. It is only available with the outer tub assembly.
This part has a D-shaped motor shaft and this motor runs at 1/4 horsepower and carries 4.5 amps.
This blower wheel does not come with a spring clamp, but it does have twenty fins and it is designed to fit a 3/8 of an inch motor shaft.
The bolt is built into the support so if the bolt is broken, you need to replace the kit.
This motor conversion kit comes with a variable speed high speed induction motor, a motor control board and a wiring harness. The motor control is NOT available separately.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.